Keytec MCI operating instructions Keylock KL, Smartcard read/write device SCR

Swipe direction

Fig. 7 Magnetic stripe reader

The parameters of the MSR can be set and/or modified using the corresponding Preh programming software.

You can find further information, as well as the associated software, in the Internet under http://www.preh-keytec.com.

Important notice: Please hold the magnetic card near the upper edge during a swipe.

4.2 Keylock (KL)

The optional keylock (Figure 8) module has 5 positions and is supplied with 3 different keys.

Turning direction

Fig. 8 Keylock

All keys can be inserted and removed in both positions 0 and 1.

The following switch positions can be set with the three keys:

•SUP key: 0 1 2 3 4

•REG key: 0 1

•X key: 0 1 2

By default, the code for the new switch position is transferred to the computer when the key is turned.

The parameters of the keylock can be set and/or modified using the corresponding Preh programming software.

You can find further information, as well as the associated software, in the Internet under http://www.preh-keytec.com.

4.3 Smartcard read/write device (SCR)

Contact-

surfaces

Fig. 9 SCR module

The EMC 3.1.1- and ISO 7816-certified SCR module of the MCI family allows you to read and write chip cards of types T=0, T=1, I²C, 2-wire, 3-wire and PTS.

PC/SC drivers for the popular Windows operating systems (as of Windows 98) are available as the software interface. A CT-API interface can be placed on the PC/SC interface.

In order to read or write a chip card, carefully insert the chip card into the read slot; make sure that the chip contact surfaces face in the direction of the keypad (Figure 9). A slight click indicates that the end position has been attained. Reading or writing can now be carried out.

You can find further information, as well as the associated driver software, in the Internet under http://www.preh-keytec.com.

MCI_Manual_V13.doc Page: 6 of 20 03555-120