Keyspan SX-18D user manual 4 44-pin Connector, Battery Compartment

Page 11

3.3.4 44-pin Connector

Install the 1.8” Hard disk drive into this connector as shown in the picture below. Ensure that the hard disk drive is connected in the correct direction.

3.3.5 Battery Compartment

Select the type of AA battery used : Alkaline or NiMH Rechargeable Batteries. Do not mix the battery type, and remember if you are using rechargeable batteries, make sure they are fully charged before use.

* Select type of battery.

* Insert the batteries and close the cover.

Do not insert the battery in reverse polarity.

User Manual

7

Image 11
Contents Model SX-18D Page Table of Content Page Introduction LED Indication ConnectorsFunctional Description Minimum System Requirement Product SpecificationsElectrical Specifications Product DimensionBundled Accessories Button Description User Interface DescriptionCompact Flash Memory Card Slot Slot #2 Mini USB connector2 SD/MMC/MS/SMC Memory Card Slot Slot #1 Battery Compartment 4 44-pin ConnectorDevice Operation Standalone Mode CopyUSB mode Operating System Supported Chatper 5 Windows 98SE/ME InstallationInstall Device Driver on Windows 98 SE / ME Page Troubleshoot Verify Win98SE/ ME has properly installed the device driverConfigure new hard disk in Win98SE / ME Installing New HDD on Windows 98SE / MECheck that Instep EzII DRIVE0 is present Page Page Page Format New HDD in Windows 98SE / ME Page Verify windows has properly installed the device driver Windows 200x / XP InstallationClick the Disk Management icon Create Master Boot Record on the new hard diskPage Create Primary Partition Record on the new hard disk