National LM95235 manual The Screen should look like this

Page 6
6.The Screen should look like this:

6.The Screen should look like this:

Local (on-chip) and remote temperatures should read continuously. The user can experiment with the different settings of Address BF.

7.If the user clicks the 06-FF tab the next screen will look like this:

.

The user can also select the 3904 diode or the processor thermal diode called “90 nm”.

The user can experiment with the Mask settings. Also the user can change the conversion rate. The next screen shows the possibilities for the Conversion Rate.

© Copyright 2006 National Semiconductor Corporation

6

www.national.com

Page 5 Page 7
Image 6
Page 5 Page 7
Contents LM95235 Evaluation Board User’s Guide LM95235 Evaluation Board User’s GuideTable of Contents LM95235 Evaluation Board User’s Guide References 1.1Block Diagram 1.0 Introduction2.0 Quick Start 6. The Screen should look like this Copyright 2006 National Semiconductor Corporation 2.1 Quick Start Diagram Important! NO EXTERNAL POWER SUPPLY OR SIGNAL INPUTS ARE REQUIREDNational Semiconductor Description Connector Label3.0 Functional Description Number4.0 Software Installation and Operation 4.2 Operation4.1 Installation 5.1 Electrical Specifications Power Requirements 5.2 Electrical Schematic5.0 Electrical and Mechanical Specifications NO EXTERNAL POWER SUPPLY INPUTS ARE REQUIRED5.3 Evaluation Board Layout Figure 5.3 Layout diagram of the LM95235 Evaluation BoardNote socket and socket area not stuffed Part 5.4 Bill of Materials for LM95235 Evaluation BoardReference PCB Footprint5.4.2 Evaluation Board Basic Dimensions 5.4 Mechanical Specifications5.4.1 Operating Mechanical and Environmental Specifications 5.4.3 Electrostatic Discharge ESD PrecautionsLIFE SUPPORT POLICY BANNED SUBSTANCE COMPLIANCE
Top Page Image Contents