National Geographic Your Essential Guide to the Thermometer and Wireless RCC Clock

Indoor/Outdoor

Wireless Thermometer With RCC Clock

Instruction Manual

Monitor:

A.Time

B.Date

C.Battery Icon

D.Indoor Temperature

E. Signal Detection Icon

F. Outdoor Temperature

G.RCC Icon

H. Alarm Icon

I. Wave OK Icon

1.Max./Min. Button

2.Alarm Button

3.Clear Button

4.Snooze/Light Button

5.(+) Button

6.Set Button

7.(-) Button

8.Wave Button

9.Re-Sync Button

10.DST/Time Zone Button

11.ºC/ºF Button

12.Reset Button

Remote Sensor:

13. Reset Button

Before You Begin

1.0 Set up procedure:

1.Insert batteries into the monitor first and then press the RESET button once.

2.Place the monitor as close as possible next to the remote sensor and insert the batteries into the remote sensor and press the RESET button.

3.Position the monitor and remote sensor within effective transmission range, which in usual circumstances is 20 to 45 meters. The range is affected by the building materials and where the monitor and remote sensor are positioned; try various locations for the best results. (See section 3.1).

Note: The remote sensor should be placed in a shaded area for accurate readings

1.1 Getting Started

Once the remote sensor has been powered up (or the RESET button has been pressed), the transmission signal is immediately sent to the monitor. The monitor will attempt to search for the signal for 5 minutes.

Once the signal is received, the dashes (--.-°F) on the monitor will change to the current outdoor temperature. If after 5 minutes the screen does not change to show the outdoor temperature, press the RE-SYNC button on the monitor. The monitor will now attempt to search for the signal for another 6 minutes.

(