MPI Technologies 2100 manual AS/400 Settings for Version, Configuring PSF with Crtdevprt on V3R1

Printer Requirements:

The recommended memory configuration is as follows:

Requirement	Minimum	Recommended	Recommended
	installed	minimum memory	minimum memory
	memory	(simple text)	(pages with overlays
			or graphics)
A4/Letter simplex	8 MB	8 MB	12 MB

Printer

HP2100

Minimum Printer firmware date code

19990105

IPDS DIMM firmware(or later versions)

S93 162.084

HP JetDirect EIO (600 N J3111A/Ethernet)

HP JetDirect EIO (600 N J3112A/Tokenring)

HP JetDirect EIO (600 N J3113A/10/100Tx Eth)

HP settings:

1.Set the IP, Subnet Mask, and Gateway address on the JetDirect card.

2.The printer's PS wait time-out shall be set to 300 sec.

3.The JetDirect card's IDLE TIMEOUT shall be set to 3600 sec or 0 (zero).

4.Remember to power cycle printer to enable new settings.

4.1AS/400 Settings for Version 3.1

To configure IPDS printing on AS/400 V3R1, you must use two commands:

-CRTDEVPRT

-WRKAFP2

4.1.1 Configuring PSF with CRTDEVPRT on V3R1

On V3R1, at the AS/400 command line, enter a command in the form:

CRTDEVPRT DEVD(HP_IPDS) DEVCLS(*RMT) TYPE(*IPDS) MODEL(0) AFP(*YES) AFPATTACH(*APPC) FONT(11)RMTLOCNAME(TCPIP) FORMFEED(*AUTOCUT) TEXT('IDATA IPDS DIMM')

11