Moen 200-0564 Scanning the Channels, Turning CHANNEL-STORAGE Banks OFF and on, Moving Frequencies

frequencies that the scanner cannot tune, and try to search in that range, the scanner beeps and does not search.

If you set a search range that crosses over into a range of

frequencies that the scanner cannot tune, the scanner searches only up to the limit of tunable frequencies and returns to the starting frequency.

SCANNING THE CHANNELS

To begin scanning channels or to start scanning again after monitoring a specific channel, press SCAN.

The scanner scans through all channels (except those you have locked out) in the active banks.

Notes:

You must store frequencies into channels before the scanner can scan them.

The scanner does not scan empty channels.

To change the scanning direction, press Up or Down Arrow.

TURNING CHANNEL-STORAGE BANKS OFF AND ON

To turn off banks while scanning, press the bank's number key until the

bar under the bank's number disappears. The scanner does not scan any of the channels within the banks you have turned off.

Notes:

You cannot turn off all banks. There must be at least one active bank.

You can manually select any channel in a bank, even if the bank is turned off.

To turn on banks while scanning, press the bank's number key until a bar appears under the bank's number.

MOVING FREQUENCIES

Moving a Frequency from a Monitor Memory to a Channel

1.Press PGM.

2.Use the number keys to enter the channel number where you want to store the monitor frequency, then press PGM again.

3.Press MON. M, the channel number, and CH flash.

4.Enter the desired monitor memory's number (1-40), then press MON again. The selected monitor memory's frequency appears.