Microstar G41M manual Locking switch

Page 20

MS-7563 Mainboard

9.Press down the load lever lightly onto the load plate, and then se- cure the lever with the hook under retention tab.

11.Press the four hooks down to fasten the cooler. Then rotate the locking switch (refer to the correct direction marked on it) to lock the hooks.

10.Align the holes on the mainboard with the heatsink. Push down the cooler until its four c lips get wedged into the holes of the mainboard.

12.Turn over the mainboard to con- firm that the clip-ends are correctly inserted.

Mainboard

locking switch

Hook

Important

1.Read the CPU status in BIOS (Chapter 3).

2.Whenever CPU is not installed, always protect your CPU socket pin with the plastic cap covered (shown in Figure 1) to avoid damaging.

3.Mainboard photos shown in this section are for demonstration of the CPU/ cooler installation only. The appearance of your mainboard may vary depend- ing on the model you purchase.

2-6

Image 20
Contents G41M series MS-7563 v1.X MainboardCopyright Notice TrademarksRevision History Technical SupportSafety Instructions Micro-Star International MS-7563 FCC-B Radio Frequency Interference StatementWeee Waste Electrical and Electronic Equipment Statement Page Vii Contents DOT Dynamic OverClocking Getting Started Getting StartedMainboard Specifications LANIDE SataMounting SlotsForm Factor Mainboard Layout G41M Series MS-7563 v1.X Micro-ATX MainboardPacking Checklist Hardware Setup Hardware SetupQuick Components Guide CPU Central Processing Unit Introduction to LGA 775 CPUCPU & Cooler Installation Lift the load lever up and open the load plate Locking switch DDR2 MemoryDual-Channel Memory Population Rules Installing Memory Modules Volt NotchPower Supply ATX 24-Pin Power Connector ATX1ATX 12V Power Connector JPW1 JPW1Back Panel Audio Ports LEDConnectors Floppy Disk Drive Connector FDD1IDE Connector IDE1 FDD1Serial ATA Connector SATA1 ~ SATA4 SATA2 SATA4 SATA1 SATA3Fan Power Connectors CPUFAN1, SYSFAN1/2 Chassis Intrusion Connector JCI1CPUFAN1SYSFAN1/2 JCI1JSPD1 IEEE1394 Connector J13941 optionalPDIF-Out Connector JSPD1 Front Panel Connectors JFP1, JFP2 CD-In Connector CDIN1JFP2 JFP1 CDIN1Front Panel Audio Connector JAUD1 TPM Module connector JTPM1optionalJAUD1 JTPM1Front USB Connector JUSB1 ~ Serial Port Connector JcomJUSB1~2 USB 2.0 BracketParallel Port Header JLPT1 JLPT1JBAT1 JumperClear Cmos Jumper JBAT1 PCI Peripheral Component Interconnect Slots SlotsPCI Peripheral Component Interconnect Express Slots PCI Interrupt Request Routing Bios Setup Bios SetupEntering Setup Press DEL to enter SetupControl Keys Getting HelpGeneral Help F1 Main MenuMain Menu Exit Without Saving Bios Setup Load Optimized DefaultsSave & Exit Setup Standard Cmos Features Bios Setup Device / Vender / Size LBA/Large ModeDMA Mode Hard Disk S.M.A.R.TMS-7563 Mainboard System Information Advanced Bios Features Hpet TCG/TPM Support Integrated Peripherals Bios Setup On-Chip IDE Controller RAID ModeDevice Configuration Parallel Port ModeAcpi Standby State Power Management SetupAcpi Function Bios Setup Power Button Function Restore On AC Power LossWakeup Event Setup Wake Up Event ByResume by RTC Alarm MS-7563 Mainboard Resume by PCI-E DeviceMonitor Chassis IntrusionCPU Smart FAN Target SYS FAN 1 ControlBios Setting Password Cell Menu MS-7563 Mainboard Configure Dram Timing by SPD CAS LatencyCLTRCD TRPBios Setup TWR Adjusted Dram Frequency MHzAdjust PCI-E Frequency MHz Auto Disable DIMM/PCI FrequencyMS-7563 Mainboard Load Fail-Safe/ Optimized Defaults Realtek Audio Click Realtek HD Audio Driver Installing the Realtek HD Audio DriverInstallation for Windows XP/Vista Realtek Audio Software Configuration Sound Effect Environment SimulationMS-7563 Mainboard Equalizer Selection LoadRaise the key Remove the human voice Lower the key Realtek Audio Frequently Used Equalizer SettingKaraoke Mode Adjust Volume Playback multi-streaming and click OK to save the setupMixer Multi-Stream FunctionRealtek Audio Tool MS-7563 Mainboard Playback controlUte Recording control Ute Realtek AudioSpeaker Configuration Audio I/ORealtek Audio Connector Settings Disable front panel jack detection optionOutput Source PdifOutput Sampling Rate Realtek Audio Test Speakers Microphone 3D Audio Demo Information Channel Mode for Stereo-Speaker Output Hardware SetupConnecting the Speakers Line Out Rear channels Line Out Rear channels Line Out Center and Subwoofer channel Line Out Front channels Dual Core Center Activating Dual Core Center Dual Core Center MainIntroduction Sharp mode Smooth mode Clock DOT Dynamic OverClocking Clock Voltage FAN Speed Temperature User Profile Dual Core Center