Marshall electronic V-R241-DLW manual IMD Fixed Config Submenu

Page 25

IMD Baud Rate

Use this setting to choose the baud rate. The baud rate must be set in conjunction with the controlling device. Available baud rates are 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200. The TSL v4.0 protocol is fixed at 38400 bauds.

IMD Name (S/N)

Use this setting to assign a name to each screen when using the Image Video or Marshall-IV protocols. The IMD name is equivalent to the Image Video serial number and is used by the Image Video controlling device to identify each screen. The default IMD Name(S/N) is “M00000.” It is recommended to maintain this naming scheme in order to avoid serial number conflicts with other Image Video devices on the same serial bus. Each name can be up to 16 ASCII characters.

Press RotoMenu™ knob to edit the IMD Name. Rotate the RotoMenu™ knob t o move the cursor. Press the RotoMenu™ knob with the cursor on the character to be changed, then rotate the knob to scroll through the character set . Press the RotoMenu™ knob to choose a character.

IMD Tally Mode

Use this setting when using Image Video tally control. Choose one of the following settings, in conjunction with the Image Video controlling device. T1, T2, T1T2, T2T1, T1-,T2-,T1T2-,T2T1-. Consult Image Video documentation for further information.

IMD Fixed Config Submenu

IMD Fixed Configuration Submenu

IMD Fixed Color

Use this setting to choose the color of the IMD Fixed String text (see below). Available colors are red, green, and yellow. This setting does not affect text color when using IMD text via the Image Video or TSL v4.0 protocols (text color is set via the protocols).

IMD Fixed Align

Use this setting to choose the horizontal alignment of the IMD text. IMD text can be justified on the left, center or right of the screen. This setting is overridden when using IMD text via the Image Video protocol (alignment is set via Image Video protocol).

25

Image 25
Contents Model No. V-R241-DLW Operating InstructionsThis page intentionally left blank Contents 1920 x 1200 Full Resolution 24 Panel FeaturesInstallation Installation and Initial SetupConnections, Power-On and Initial Setup UnpackingPower Button Front Panel FeaturesRS-422/485 Serial Interface Rear Panel FeaturesFollowing SDI standards are supported by the V-R241-DLW Compatible Input FormatsDLW Monitor Layouts Waveform Monitor Mode Full Screen Video Mode On-Screen Menu On-Screen Menu Marker Setup SubmenuMarkers Center Marker Marker BackgroundMonochrome Mode Video Config SubmenuBlue-Only Mode Aspect Ratio Settings Pixel-to-Pixel ModeDVI-A CSC Mode DVI-Analog input only Analog Phase DVI-Analog or VGA input onlyDVI-D CSC Mode DVI-D input only Curtain ColorSystem Config Submenu Color Config SubmenuHdmi CSC Auto Hdmi input only, via the DVI-I interface User-Definable Function Buttons Saving and Loading User PresetsIMD State OSD Config SubmenuStatus Display LED Tally OSD TallyAnc. Timecode Audio Monitor OSD TimeoutCC Monitor Closed Captioning Overview IMD Config SubmenuIMD ID # IMD Group #TSL Tally SourceIMD Fixed Config Submenu Closed Captioning Submenu ServiceIMD Fixed String ModeWave/Vector Submenu Waveform ModeColorize Waveform Waveform ScaleAncillary Submenu DID/SDID Software Version Display Service SubmenuPanel SpecificationsDimensions Warranty MaintenanceScreen Cleaning Burn-In WarningThis page intentionally left blank 2010-1229