Turbosound TA-880 user manual Safety Notes on Rigging

Page 23

user manual

TA-880

Safety Notes on Rigging

The Turbosound TA-880 system has been designed and constructed to a high standard of safety, and tested to the most demanding of specifications with a safety factor of 13:1. Always wear protective headwear, footwear and eye protection in accordance with local regulations. Anyone involved in flying ANY sound system, especially in a touring capacity, should take note of the following advice:

The rigging of a flown sound system may be dangerous unless undertaken by qualified personnel with the required experience and certification to perform the necessary tasks. Fixing of hanging points in a roof should always be carried out by a professional rigger and in accordance with the local rules of the venue. The house rigger and/or building manager must always be consulted.

You should observe particularly the following points:

Inspect rigging systems and cabinets for damage before proceeding to assemble a flown array. If any parts are damaged or suspect, DO NOT USE THEM.

When initially ratcheting a column of speakers it is good to bear in mind the expected angle of inclination so as to avoid ending up with too much of the strap left on the ratchet. This is important because the ratchet can only take three complete turns before it releases itself.

WARNING: If a tilt strap is released suddenly, the column of enclosures may tend to swing violently forwards and care must be taken to avoid danger to persons in the vicinity. It is essential to check that nobody is standing immediately in front of the column, and to give a suitable warning, before the strap is released. Ideally, two persons should support the column from the side whilst the strap is released, or alternatively the bottom row may be returned to the ground before release. In any event it is essential that all personnel in the vicinity are aware that the system is about to move and that they must keep clear.

Aspect Flying System components have been individually tested in accordance with the following regulations:

•The Health and Safety at Work Act 1974

•The Supply of Machinery (Safety) Regulations 1992

•The Lifting Operations and Lifting Equipment Regulations 1998

Each component is covered by a Record of Load Test Certificate, which may be obtained on request from Turbosound, quoting the indentifying number(s) from the flying equipment. A copy of a sample certificate is reproduced overleaf.

TA-880 user manual

Page 23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Aspect TA-880 System TA-880 TA-880 Amplifier Rack Signal Wiring Output Connections TA-880 EC Declaration of Conformity Turbosound Aspect System Concepts IntroductionAspect Polyhorn Concept Aspect TA-880 Turnkey System Concept Amplifier Racks Loudspeaker Management System LMS ConceptLMS-D26/D6 Loudspeaker Management Systems Aspect Loudspeaker Components Power AmplifiersDigital Controllers TA-880H Mid/High Enclosure TA-880L Low Frequency EnclosureTSW-218 Subwoofer TA-880LM Low-Mid Enclosure TA-880HM High-Mid EnclosureTransportation Aspect trapezoidal Flying System Overview Flying and StackingRunning Turbosound GigMate / Ease Focus for the first time Gigmate Acoustic SimulationRigging System SetupMapping Properties Audience AreaDesigning a system TA-880 TA-880 TA-880 Safety Notes on Rigging Sample Certificate of Load Test Horizontal Coverage Flying HardwareVertical Coverage Wide and Narrow Flybar settingsTwo-wide trapezoidal flybar FB-880/2W Bottom ViewThree-wide trapezoidal flybar FB-880/3W Flying Chains Short Chain AssemblyFlying Swords Tilting Strap 59mTA-880 TA-880 Flying a vertical column of TA-880 trapezoidal cabinets TA-880 Sword hole position Inter-cabinet angle Single horizontal row Flying a cluster of TA-880 trapezoidal cabinetsWide x 2 deep TA-880H array Wide x 3 deep TA-880H array Tight-packed Flying Assemblies TA-880 Aiming directivity of the stack Bass Enclosure arrayingGround stacking Unpacking Mechanical InstallationLMS Series Loudspeaker Management Systems IntroductionLMS-D6 Loudspeaker Management System LMS-D6 Rear Panel Functions Mains PowerPowering Up Voltage SettingsSafety Earthing AC Power FusingAudio Connections Input and Output Connector WiringTime correction for loudspeaker driver placement LMS-D24 and D26 Loudspeaker Management Systems FeaturesFront Panel Functions TA-880 Rear Panel Functions Creating a Crossover Selecting a Factory PresetOperating the LMS-D24 and D26 Starting up Navigation and Viewing Parameters A Freq Width Gain EQ1 100Hz 1.4Q 0.0dBNavigation Out1 Freq Width Gain EQ1 100Hz 1.4Q 0.0dBPreset Recall PresetsPreset Store Preset Name Store My SystemStereo / Mono Formats DSP Processing Layout Input DSP block diagramOutput DSP block diagram DSP processing Input Channels A Delay 1.50msA Freq Shape HPF 20.0Hz LR24 Parametric filters Parametric EqualisationHigh and Low shelving filters Output Channels Gain and Polarity DelayHigh and Low Pass Filters Out1 Freq Shape LPF 2.50k LR24Out1 Freq Slope Gain EQ- 100Hz 12dB 0.0dB Routing LimitersUtilities Utility functions Serial Comms Port Audio Output Connectors Racking, Cables and Connections AMP-890 Aspect System Amplification RackInput Connections OptionsOutput Connections Amplifier Rack Signal WiringMid-High Outputs Break-out Cables NL4 bass Extension Cables Break-out cables NL8 mid-highMains Connections General Features & Facilities T-45 High Efficiency Audio Power AmplifiersFront Panel Functions T-25 Front Panel Functions T-45 Mechanical Installation Audio Connections & Controls Voltage SettingVoltage Range Input Impedance Gain and Sensitivity SettingsPolarity Damping Factor Attenuation & Gain SettingCooling System Long Speaker LinesTA-880H TA-880HM TA-880LM Appendix a Technical SpecificationsTA-880L TSW-218 Appendix B Warranty TA-880

TA-880 specifications

The Turbosound TA-880 is a high-performance audio solution designed for professional live sound applications. This arrayable large-format loudspeaker system offers remarkable acoustic power, clarity, and reliability, making it a popular choice among sound engineers and event organizers.

One of the standout features of the TA-880 is its advanced driver technology. The loudspeaker is equipped with dual 18-inch neodymium low-frequency transducers that provide deep, punchy bass and impressive output levels. The high-frequency section is supported by a 3-inch titanium compression driver, delivering crystal-clear highs that ensure speech intelligibility and musical detail, even in large venues.

The TA-880 system employs Turbosound's proprietary Waveguide technology, which enables exceptional dispersion control. This means that the sound reaches the audience evenly, minimizing dead spots and providing a consistent listening experience. The speaker's broad horizontal dispersion pattern allows for wider coverage, making it ideal for various settings, from concert halls to outdoor festivals.

Additionally, the TA-880 features a robust, durable construction that can withstand the rigors of touring and extensive use. Its weather-resistant design makes it suitable for both indoor and outdoor applications, ensuring reliability in diverse conditions. The system is also lightweight, facilitating easy transport and setup, allowing sound professionals to focus on delivering exceptional sound rather than wrestling with heavy equipment.

Integration is made seamless with the TA-880 through its compatibility with Turbosound's proprietary digital signal processing (DSP) technology. This innovative feature enables users to fine-tune the system according to specific venue requirements and performance criteria, further elevating sound quality. It also allows for network control, enabling real-time monitoring and adjustments from a single interface.

The TA-880 system is versatile, suitable for a range of applications including concerts, corporate events, and festivals. It can be used as standalone units or as part of a larger array configured for larger venues. Its combination of high output capability, intelligent design, and industry-leading technology makes the Turbosound TA-880 a preferred choice for those who demand excellence in audio performance.

In summary, the Turbosound TA-880 combines advanced driver technology, innovative dispersion solutions, and robust construction, making it an indispensable tool for sound professionals aiming to deliver an unforgettable auditory experience.
Top Page Image Contents