Ovation Software Label Printer manual Part Number Revision B2

Page 2

CG Triumvirate is a trademark of Agfa Corporation.

CG Times, based upon Times New Roman under license from The Monotype Corporation.

Ovation, SEAQ, and PC Batch are trademarks of Datamax Bar Code Products Corporation.

As an Energy Star Partner, Datamax Corporation has determined that this product meets the Energy Star guidelines for energy efficiency.

Firmware (Software) Agreement: The enclosed Firmware (Software) resident in the EPROM’s is owned by Licensor or its suppliers and is licensed for used only on a single printer in the user’s Trade or Business. The User agrees not to, and not to authorize or permit any other person or party to, duplicate or copy the EPROM’s or the information contained in the EPROM’s. The firmware (Software) is protected by applicable copyright laws and Licensor retains all rights not expressly granted. In no event will Licensor or its suppliers be liable for any damages or loss, including direct, incidental, economic, special, or consequential damages, arising out of the use or inability to use the Firmware (Software).

Information in this document is subject to change without notice and does not represent a commitment on the part of Datamax Bar Code Products Corporation. No part of this manual may be reproduced or transmitted in any form or by any means, for any purpose other than the purchaser's personal use, without the expressed written permission of Datamax Corporation.

© Copyright 1999 by Datamax Corporation

All rights reserved. Printed in the United States of America.

Part Number: 88-2185-01

Revision: B2

Image 2
Contents Ovation2 Operator’s Manual Part Number Revision B2 Agency Compliance and Approvals Page Important Safety Instructions Page Contents Troubleshooting Introduction Printer OverviewUnpacking and Inspection Additional RequirementsConnecting Power Connecting power to the PrinterInterfacing to the Printer Interface CablesLoading Media Loading MediaLoading Media for Peel Configuration Loading Media for Peel ConfigurationLoading Ribbon Thermal Transfer Option Ribbon Hub RemovalSelecting the Print Type Size Media Width Adjustment Power-up Configuration and Self-Test 12 Configuration Test LabelFunction Value Setting the Printer to the Factory DefaultsFactory Default Settings Switches and Indicators Switch/Indicator FunctionAvailable Options Thermal TransferPC-Batch Software Ovation2 Programming Commands Printing LabelsImmediate Commands CommandSystem-Level Commands Char Description FormatSystem-Level Commands concluded Label-Formatting Commands Description FormatLabel-Formatting Commands concluded Special Label-Formatting CommandsFont-Loading Commands Programming ExamplesExample line Configuration Command String Example Stxkd @A@ CR@ Sets the printer to gap edge media Memory Cartridges Modules Inserting a Memory CartridgeMaintenance Area Method IntervalCleaning the Printhead Cleaning the PrintheadFine Printhead Adjustment Fine Printhead AdjustmentPrinthead Replacement 203 DPI Disconnecting the Printhead CablePrinthead Replacement 300 DPI Ovation2 Troubleshooting Ribbon does not advance Label advances 12 inches before a fault indication Ovation2 Page Ascii Control Code Chart Appendix aAscii Control Code Chart Appendix B Printer Specifications Electrical Available Bar Codes Ovation2 Table B-1 Valid Human-Readable Font Ascii Characters Available Fonts and Bar CodesFonts Font Sizes Lower caseOvation2 Ovation2 Table B-3 Bar Code Characteristics Bar CodesBar Code E Code Bar Code a Code 3Bar Code C UPC-E Bar Code G EAN-8Bar Code M 2 Digit UPC Bar Code N 5 Digit UPC Bar Code I CodeabarBar Code K Plessey Bar Code O CodeBar Code u UPS MaxiCode Bar Code v FIM Uppercase R Error CodesLowercase Uppercase TError Codes Warranty Information PrinterWarranty Service Procedures Thermal PrintheadGeneral Warranty Provisions Limitation of LiabilityOvation2