Perlick Installation and Operating Instructions, Model Nos DC72S DC84S DC96S, End View TopView

Installation and Operating Instructions

Sizes and Specifications, Concessionaire Dispensers

Model Nos.		dC72S	dC84S	dC96S
keg capacity		2 Keg	3 Keg	4 Keg
CABINET	Length Ins. (mm)	72” (1829)	84” (2134)	96” (2438)
Dimensions
	Depth Ins. (mm)	243/4” (629)	243/4” (629)	243/4” (629)
w/o Bumpers	Height Ins. (mm)	341/2” (876)	341/2” (876)	341/2” (876)
No. of dispensing heads		1	1	2
No. faucets		2	2	2
condenser unit h.p.		1/4	1/3	1/3
running load - amps		5.9	7.5	7.5
Ship wt lbs. (kg)		445 (202)	505 (229)	545 (247)
Interior		Door sill: High strength polyethylene. Door pan and ceiling: High strength polystyrene.
		Floor pan: Satinless steel. Walls: Galvanized steel.
exterior		All Models: The top is stainless steel. The back, front and sides are stainless steel. Bottom is
		galvanized steel. Doors and grilles are stainless steel.
Refrigeration		R-134a capillary tube-type. Aluminum fin and copper tube evaporator, epoxy coated coil. Forced air
		into dispensing head. Adjustable temperature control. Self-defrosting. Pull-out condensing unit for
		service and cleaning.
Ventilation		Front ventilated.
electrical		115 Volt, 60 Hz., 1 Phase AC. Furnished with three prong, six foot NEMA5-15P cord.
		Contact Perlick for other voltage/frequency requirements.
Plumbing		Evaporator condensate has been plumbed to a condensate pan located in the compressor housing.
Insulation		Foamed-in-place polyurethane; 2” walls, 11/2” top and floor.
OPTIONAL ACCESSORIES		• Keg Couplers	• Faucet Locks
		• Regulators	• Optional Dispensing Heads

NOTE: This equipment is intended for the storage and display of non-potentially-hazardous bottled or canned products only.

Form No. Z2283 Rev. 06.14.10

End View

TopView

Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.

2