Document Guide Installation
The Document Guide is a clip in durable plastic part that attaches to the printers Validation Roller to provide a right side guide for an inserted form.
NOTE: Before installing the Document Guide make sure the area where the guide is to be installed is free of any dust debris or contamination that could inhibit the movement of the Validation Roller.
The Document Guide is installed by attaching it to the Validation Roller. The guide is installed vertically with the bot- tom of the guide clipped into the Valida- tion Roller in the rollers notch on the right side. The tapered tab end of the guide needs to be toward the top of the printer. Align the bottom two extensions of the Document guide so that they are left of the MLV Roller Gear. Make sure an inserted form will not catch on the guide.
Tab
MLV Gear
When the Document Guide is attached the Print is Left Justified to the 2” Print Zone on the back of a 2 3/4” X 6” standard check.
Note: The Print Field is 2.5” wide. Left Justifi- cation can overlap into the 1” right zone.
3 Inches | Print Zone | 1 Inch |
2 Inches for 6” Check | ||
1.75 Document Stop |
|
|
| Print field is 2.5” Wide |
|
| 3 Inches |
|
The print field will be 1/4” left of a standard 2 3/4” X 6” form when inserted vertically and aligning with the docu- ment guide.
1.75Document Stop
Print field is 2.5” Wide 
1 Inch
2.75 Inches
Pertech Resources Inc. | November 2005 | 220321A | 6 |