platform of the main unit till it clicks. Screw the pivot back to secure the base of the cashier display on the display platform of the main unit as in drawing below. Remove the cable cover on the display platform (same way as the instructions for CRT model) and connect the VGA connector of the 12.1” TFT LCD through the cable cover opening into the rear room. Reserve some sag in the cable so that the LCD cashier display will be allowed to turn and reinstall the cable cover.
CUSTOMER DISPLAY When the PST7700 series
is ordered with the customer display option, the terminal will be delivered with the base tube for the display already fitted to corner of
the display platform. The customer display head can be easily inserted into the base
tube after first inserting the signal cable. Pull out the release button on the base tube to allow the inner
tube of the display head to travel
down into the base tube. Please ensure that the latching track on the
Please NOTE: The VFD connector must always be populated either with the VFD terminator or a plug from the customer display (Failure to do this will prevent COM1 from working correctly).
Close the back door then slide the two door latches outward and the installation is completed. Please refer to the instructions in the part “TO USE THE PST SYSTEM” for later adjustment on the most comfortable position and direction of the customer display.
PROGRAMMABLE KEYBOARD
The PST terminal is equipped with an extremely versatile programmable keyboard. The application of this keyboard requires no software driver and is free from any software compatibility issue. This keyboard comes in 2 different layouts : KB112 for PST7700/PST7705 and KB136 for PST7730/PST7735. The key tops of the 2 layouts are different in their basic sizes, so all the accessories for the 2 layouts cannot be mutually exchanged. However, they are common in structure.
The keyboard is shipped from the factory with the key tops fitted, but
Part 9