Sleep Mode
After the scanner has been inactive for a period of time, the laser automatically turns off; then the motor will turn off and the scanner will enter the “Sleep Mode”, the blue status LED keeps blinking as indication. To wake up the scanner, simply present an object close to the scan window, or press the function button.
Note: The scanner includes a motion sensor that detects activity in front of the scan window. The detecting distance is up to about 15cm (6 inches) from the window.
Change Beeper Volumn Using Function Button
The beep tone, volume and duration are programmable by advanced programming codes. And the beep volume is adjustable by pressing the function button
The volume has 3 different levels, low, medium, loud, follow the following steps to tune the volume.
Always keep the scanner operating.
Press and hold down the function button for about 3 seconds, the scanner will enter (medium
Release the button when you hear the right beeps. The scanner beeps accordingly.
Note: .The volume setting in this way is not saved in
|
| LED Indications |
A dual color | ||
LED status | Indication | |
Off |
| No power supplied to the scanner |
Steady blue light | The scanner is on and ready to scan | |
One red flash | A barcode has been successfully decoded. | |
Steady red light | A barcode has been successfully decoded, but the object is not | |
|
| removed from the scan window. |
|
| The scanner is in programming mode. |
Flashing blue light | The scanner is in sleep mode. | |
Steady red | and blue | This indicates the scanner has a motor or laser failure. For motor |
light |
| failure, a periodic beep is sounded. Return the unit for repair. |
Alternate | flashing | The scanner detects failing power. Please check the power |
red and blue light | supply. |
Page 8