The header is printed in text mode and the rest part of this slip is printed in page mode. If FEED button is pressed at this moment, a font table will be printed in text mode again. To exit the test printing, please turn the printer off and on again.
SPECIAL ADJUSTMENTS
Paper Near End Sensor |
| |
The near end sensor for | Paper Roll | |
paper roll in the printer is | ||
Shaft Hold | ||
able to have the printer | ||
| ||
work with paper rolls of | Sensor Block | |
several bobbin sizes. |
| |
Please refer to the picture | Sensor Position |
at right for the inside of the paper roll compartment that there are a plastic
thumb wheel for bobbin size adjustment and a sensor block in the wall. Turn the thumb wheel to adjust the proper position of sensor block. For desktop application, the sensor block should be above the bobbin seating on the 2 support rollers on bottom of paper compartment when paper near end. The acceptable paper roll bobbin outer diameter is between 18 and 24 mm.
58mm Paper Spacing Plate
C
B
C
A
B
58 mm
ACompartment
The application of 58 mm width paper roll in this printer can be achieved through adoption of an option spacing plate and an internal DIP switch setting. Please refer to the last chapter of this manual for the DIP switch setting. Please refer to the middle picture above for the 58 mm paper spacing plate with its flange at top edge showing out. Insert the noted corners of the spacing plate into the 3 dents inside the paper roll compartment as arrowed in the left picture above with point A goes in first. Then the 58 mm paper roll sub compartment is formed as in the right picture above.
Page 8