Wall Mount Application
In wall mount application, the option kit will include screws, plastic cotters and a paper roll shaft. Screws and cotters are to be inserted to holes drilled on wall 80 mm apart center to center horizontally with the
The paper roll shaft should go through the paper roll and seat in hold on paper roll compartment wall as indicated by arrows in middle picture above and the paper roll should be in the orientation as in the right picture above. The paper near end sensor must be readjusted for wall mount application as it approaches the paper roll from different direction for desktop application.
For wall mount application, the sensor block should be under the bobbin supported through a shaft held on paper compartment wall
T31454
這是甲類的資訊產品，在居住的環 境中使用時，可能會造成射頻干 擾，在這種情況下，使用者會被要 求採取某些適當的對策。