when finish. The lock up of the print hood can then be released after this problem solved.
Please use manual cutter as temporary alternative measure once the auto cutter malfunctioned.
Advanced Analysis Tool
This printer supports Hexadecimal Dump for experienced user to view exactly what data is received by the printer. This can be useful in finding software problems.
To start the dump mode: Turn off printer; Open print hood; Hold down FEED button while turning printer on; Close the hood.
To stop the dump mode: Press the FEED button to print out the last line; Turn off the printer.
During dump mode: All commands except DLE EOT and DLE ENQ are disabled.
USEFUL TIPS
∙ Please note that only those qualified technicians may adjust several jumpers for some technical settings. Please visit our web site http://www.posiflex.com or http://www.posiflex.com.tw for details of the technical information such as driver installation, DIP switch settings and command sets etc. if required.
∙ Place the printer on a sturdy, level surface.
∙ Choose a place that is well ventilated and free of excessive dust, smoke or fume.
∙ Do not put the printer under direct sunlight or near a heater.
∙ Ideal room temperature is from 5ºC to 40ºC. Ideal humidity is from 20% to 85% RH (no condensation).
∙ Do not set any liquid or drinks such as coffee on the printer case. ∙ Do not touch any metal part to avoid possible electrostatic damage.
∙ Do not touch the areas around the print head and motor during or right after printing. It can be very hot.
∙ Do not allow the cut receipt to slide back into the cutter during the operation. As this would lead to multiple cutting at the lower edge of a receipt and the multiple cut thin slips tend to cause mechanical malfunction.
∙ Use a grounded AC power outlet with only the power cord and power adaptor furnished with the printer.
∙ Do not use a power outlet of a circuit shared with any equipment that uses
Part 14