Quick START-UP, Loading Paper | POSIFLEX Business Machines PP-8000

QUICK START-UP

LOADING PAPER

Desk Top Application

Release Button

Pix. 1

Pix. 2

Pix. 3

1.Remove the spill protect cover if the option is on.

2.Press down the hood release button to release the top hood as in Pix. 1.

3.Raise the released hood wide open manually as in Pix. 2.

4.Drop the thermal paper roll inside the printer in orientation as shown in Pix. 2.

5.Close the hood back leaving the tail of the paper roll coming out of the opening between the hood and the top cover as in Pix. 3.

6.Apply the spill protect cover while having the paper to come out of the paper exit slot of the cover if this option is used.

7.Tear off excessive paper.

When to Replace Paper

Whenever the printer gives paper out signal or a red line appears on the thermal paper, it is the proper timing for replacing the paper. Do not wait till the print engine is dragging the paper roll at the very end. Remove the leftover and replace a new paper roll as illustrated above to prevent excessive paper dust in the printer and consequently possibility for paper jam.

CONNECTING CABLES

Serial Connection

All the external connectors are in the recessed area at the rear bottom for PP-8000 series. The serial connector is a 9-PIN D sub Female connector at the right in this area. Apply the male connector of RS232 cable to this port for serial application. Please note that when serial connection is used, there must be no cable connection at the parallel port on the printer. The default protocol used in serial connection is 115,200 bps, none parity, 8 data bits, 1 stop bit. Set

Part 6