Peripheral Electronics Programming the iPod2car, Dip Switch Configuration Chart

1.6 Programming the iPod2car

Now that you have identifi ed the correct harness and dip-switch confi guration us- ing the application guide, it is now time to program the interface.

To program the interface, set the dip-switches located on the side of the interface (see Fig.1 below) to the congfi guration listed for your vehicle in the Application guide. Switches are in their default setting of “off” in the up position and are turned “on” when switched down. Refer to the chart on the bottom of this page.

This programs the iPod2car to the vehicle it is being installed in. The dip-switch- es MUST be set before the interface is plugged into the vehicle. Otherwise the iPod2car will not work correctly.

Dip Switch Configuration Chart

	1	2	3	4	5	6	7	8
Confi g. #1	ON	off	off	ON	off	off	off	ON
Confi g. #2	ON	off	off	off	off	off	off	ON
Confi g. #3	off	off	off	ON	off	off	off	ON
Confi g. #4	off	ON	off	off	off	off	off	ON
Confi g. #5	ON	ON	off	off	off	off	off	ON
Confi g. #6	off	off	ON	off	off	off	off	ON
Confi g. #7	ON	off	ON	off	off	off	off	ON
Confi g. #8	off	ON	ON	off	off	off	off	ON
Confi g. #9	ON	ON	off	ON	off	off	off	ON

Fig.1 Side view of Interface with dip switches

1 2 3 4 5 6 7 8

DIPON

10