Peripheral Electronics iPod2car instruction manual Trouble Shooting

3.2 Trouble Shooting

Symptom	Cause
No Power	Blown fuse in vehicle fuse
	block.
No Power	Bad connection
Alternator noise is heard	Improper wiring creates a
(Changes with Engine RPM)	ground loop
You can hear music from	The Firmware on the iPod
the iPod but you cant con-	may not be updated.
trol it from the radio.
Radio is not recognizing	Bad cables or cables are
iPod2car interface	not connected properly
	between converter box and
	car radio
Radio is not recognizing	Wrong confi guration on the
iPod2car interface	interface
Radio is not recognizing	Yellow and black wires are
iPod2car interface	not connected to Constant
	12V+ and Ground. (When
	applicable)
iPod Audio is Low or	iPod2car interface is con-
Distorted	nected with an external CD
	changer or other external
	factory audio source
iPod is not charging	Yellow and black wires are
	not connected to Constant
	12V+ and Ground. (When
	applicable)

Remedy

Replace fuse with same amp rating. If the fuse blows again, call tech support.

Check cable and wiring connection.

Install a Ground loop isola- tor or seek professional service from a local car audio shop.

Update the Firmware on the iPod. See section 1.2 of this manual.

Check connection and cables, push in fi rmly.

Select the right pconfi gu- ration for your car. (See section 1.5)

Please read wiring instruc- tions in chapter 2 of this manual and see if your car requires to connect the yellow and black cable to power and ground

Disconnect the factory external audio source.

Please read your vehicles section in this manual and see if your car requires to connect the yellow and black cable to power and ground

For consumer technical support call:

866-788-4237 in the US or 727-572-9255 ext.262 for international calls

Hours: 9:30 am-6:00 pm E.S.T. MON - FRI

15