Setup menu

Danish Interpretation Systems

User Manual

∙Headset Connector

On the left side, a DIN connector is located for connecting a DIS headset instead of a microphone.

∙“Display” power connector

The unit supports a dimmed backlight (on/off user selectable) in the LCD display with no external power supply connected. However special circumstances can required full light in the display. At the bottom a power connector is used for connecting a optional Power Adapter used for supplying power for full light in the display. Please note, that the interpreter set is functioning perfectly also without light in the display.

Please observe that only the Power adapter supplied with the interpreter set can be used. Other Power adapters might damage the interpreter set.

∙Loudspeaker Connector

A D-Sub 9 pole connector for connecting the LS6032 Loudspeaker unit is located at the bottom of the unit. The LS6032 Loudspeaker has a separate Volume control. The loudspeaker will be disconnected automatically if a microphone is switched on at one of the interpreter sets in the same booth (same A-language). This connector is only on some versions of the Interpreter Set.

∙DCS LAN connector

Two RJ45 sockets are located at the bottom of the unit for connecting to the previous unit (an Interpreter set or CU 6010 or an other DCS 6000 unit) and to the next unit.

The 9 digit number at the bottom of the display is the units serial number. Each of the three positions separated by dots can hold a value of 0-255 giving a maximum serial number of 255.255.255.

After some seconds the following type of screen is shown:

11	SWE	FLOOR	2
1	ITA	FLOOR	ENGLISH
3	FR	FLOOR	11
4	DAN	FLOOR	SWEDISH

This screen will be different on the various Interpreter sets, depending on the individual set-up of the Interpreter Set. If the welcoming screen does not disappear, the interpreter set has not been set- up. For setting up the interpreter set, please see next section.

A black dot in the middle of the first line indicates that the Audio out from the interpreter unit is muted. The reason for this is communication problems. Cables etc. have to be checked.

11	SWE	FLOOR ■	2
1	ITA	FLOOR	ENGLISH
3	FR	FLOOR	11
4	DAN	FLOOR	SWEDISH

Before using an Interpreter Set, a set-up of the A- language and B-language has to be done on all other interpreters’ sets.

When b and B are depressed simultaneously the set- up menu is shown:

Set up for each interpreters set

When an IS 6132 interpreter unit is connected to the CU 6010, the following start-up screen is shown

DANISH INTERPRETATION

SYSTEMS

IS6132

055.004.255

-Booth/desk no. ▲ -B-language/B-mode -Ver. and serial no. -Communication status ▼

When the unit is un-configured (has not yet received an address) the first two menus will not be available. This is indicated by the missing “-“

Booth/desk no. ▲ B-language/B-mode

-Ver. and serial no.

-Communication status ▼

Manual 01 18 04445	9