LCD backlight, AB switch with mic on | Listen Technologies IS 6132P

Danish Interpretation Systems

User Manual

LCD backlight

This menu gives the user the possibility to control the dimmed LCD backlight:

LCD	backlight:
■ON	OK
	Cancel

The user can toggle the backlight setting between ON and OFF by pressing the relay-select buttons.

Press OK to return to the Set-up menu

Only dimmed LCD backlight can be controlled using this menu – strong LCD backlight will be available if external Power Supply is connected

AB switch with mic on

AB switch with mic on means that the user can change the outgoing channel from A to B even when the microphone is active.

AB switch with mic on:

■ONOK Cancel

The feature is toggled between ON and OFF with relay-select.

This feature is typically used in two language scenarios where an interpreter is responsible for translating from language A to B and also the reverse from language B to A.

Press OK to return to the Set-up menu.

Normal operation

As mentioned in previous chapter the following type of screen is shown short time after the system is powered up:

11	SWE	FLOOR	2
1	ITA	FLOOR	ENGLISH
3	FR	FLOOR	11
4	DAN	FLOOR	SWEDISH

This screen will be different on the various Interpreter Sets, depending on the individual set-up of the Interpreter Set.

Please note, if the welcoming screen is not disappearing, the Booth number has not been set- up. For setting up the interpreter set, please see the section “Set up for each interpreters set”.

Selection of incoming language

When interpreting, the interpreter will listen to either the “Floor” language or will listen to one o f the interpreted languages. The Floor button will select the Floor language and the buttons a, b, c and d select the pre-selected languages shown on the LCD-display to the headphone output. Each of the buttons can be pre-selected to any of the interpreter channels.

When one of the buttons a, b, c and d is pressed a LED is lighted in the button pressed indicating, that this pre-select is chosen.

The two first characters in the display show the channel number (e.g. 12 or 5) and the following three characters show the corresponding language in short (see language list).

When the Floor button is pressed the Floor channel is selected and the green Floor LED is lit. Also the indication in one of the buttons a, b, c and d is removed.

OBS If the functionality, that pressing the Floor button again shall switch the listening back to the previous selection of (a, b, c or d) is required, at setting in the CU 6010 can be changed. Please consult the DIS factory for this option.

When one of the a-d channels is selected the Floor LED goes out and the audio from the selected channel is switched on instead of Floor. It is then possible to change the listening channel with the Relay select up and down push buttons. When the highest number is reached when stepping up, the counting restarts from 1.

The reverse will happen when stepping down.

Manual 01 18 04445	11