HOW TO REPAIR THE RIALTO, SAN RAPHAEL, CABERNET, AND PILLOW TALK FLOAT AND FLUSH VALVE.
INTRODUCTION
The following instructions are used to replace the plunger assembly on the flush valve for the San Raphael, Rialto, Cabernet, and Pillow Talk toilets. Refer to Fig. #11.
Screws
Cap Top
Cap
Float Rod
Float Ball
Plunger Ass'y
Gasket
Nut
Supply Hardware
Rim DiverterRim Tube
Float
Float Valve Assembly
Fig. #11
1.Loosen the screws and remove the cap top and cap.
2.Replace the Oring and plunger assembly.
3.Place the cap and cap top back on valve. Tighten with screws.
REPLACING THE
1.Refer to Fig. #12. Turn valve counterclockwise and re move.
2.To install new valve, apply a bead of silicone to the base of the gasket. Insert into hole inside tank. Press down and turn clockwise until valve is in proper position.
Trip Chain
Flapper Hooks
Flush Ball
Gasket
Twist Lock Flush Valve
Fig. #12
REPLACING THE OLD STYLE FLUSH VALVE (RIALTO AND SAN RAPHAEL ONLY)
1.Refer to Fig. #13. Loosen three screws and turn mounting hooks inward. Remove flush valve.
2.Assemble gasket to new flush valve. Position new flush valve with three screws and mounting hooks into hole in tank. Make sure mounting hooks are turned inward. Turn mounting hooks outward and tighten screws.
NOTE: TOILETS WITH OLD STYLE FLUSH VALVES CAN NOT BE FITTED WITH THE NEW TWISTLOCK VALVE.
STARTUP AND OPERATION FOR ROCHELLE & PALARRE TOILETS
The trip lever assembly actuates the rotor and flush ball to begin flush.
The float valve assembly controls the flow of water through the rotor to the rim holes and tank. The adjusting screw
- 4 -