LUSTRA SEAT REMOVAL
1.Refer to Fig. #24. Pry up seat hinge post covers and loosen screws. Remove wing nuts.
Seat Hinge Post
Covers
Screw
Wing Nut
Lustra Seat Removal
Fig. #24
2. Remove seat from toilet.
PILLOW TALK SEAT REPLACEMENT
1.Refer to Fig. #25. To install Pillow Talk toilet seat, slide hex head bolts through holes in the two hinge blocks. Slide bushings onto bolts.
2.Notice that the bushing and hinge block are serrated. This allows you to adjust the toilet seat to the correct position before tightening. Place toilet seat onto toilet by inserting the hinge block/bushing assemblies through the two holes on the toilet. Once the bushings are inserted into the holes the toilet seat can be ad justed. Adjust hinge block/bushing forward or back ward until seat position is correct. Make sure the seat is placed squarely on the toilet.
3.Thread wing nuts onto hex head bolts from underside of toilet. An indentation on the hinge block will prevent the hex head bolt from turning when the wing nut is tightened.
4.Attach bolt covers as shown.
É |
Pillow Talk Seat Replacement
Fig. #25
GENERAL TOILET TROUBLESHOOTING (ALL MODELS)
If toilet won't shut off or is leaking, perform the following procedure for initial troubleshooting, then refer to the ap propriate chart on the following pages.
1.Shut off water supply. Note the water line inside the tank.
2.Wait at least an hour and recheck the water level.
3.If the water level is at the top of the toilet's overflow tube or has not dropped, the water level may be too high, or
- 9 -