Programming the LK7000 Keyboard

The following procedure will show you how to program your LK7000 with standard (keyboard) alphanumeric characters. The keyboard can be programmed with either ASCII or Scan code information. The default

mode is the ASCII code mode.The following procedure assumes both a LK7000 keyboard and a 101 keyboard are attached.

NOTE: To run this program you must exit windows completely. Do not shell out from Windows.

1.With the correct programming graphics present. Select the cell you want to program by using the arrow keys on the 101 keyboard. The Up and Down arrows will select the row while the Shift and either the Right or Left arrow key will select the column.

2.Enter your programming text via the 101 keyboard. Continue

programming until all the keys are programmed. It is not necessary to program all the keys for the LK7000 to function properly. The maximum number of alphanumeric characters that can be programmed for any one key is 256.

NOTE: The maximum number of alphanumeric characters that can be programmed per standard keyboard is 1856.

DATA TRANSFER MENU

Dos shell

File list (*.tpl)

Load file from disk

Read from keyboard

Save file to disk

Write to keyboard

Press ESC to Quit

3.Press F2 to call up the Data Transfer Menu. There will be several choices to choose from.

4.Type W to write the programmed data into the LK7000’s non volatile memory. A “Writing Data” screen will open showing the percentage of memory written. It will take approximately 7 seconds to copy the data into the keyboard.