Set-up, Connecting the printer cable | Oce North America OP14

2. Set-up

2-1 Connecting the printer cable

CAUTION: ALWAYS turn the main switch to the printer OFF (O) BEFORE connecting the printer cable.

1	Turn the main switch located on the right side of the printer
	OFF (O) and then turn the power off to your computer as

well.

2-2 Installing the software

Perform the following procedure to install into your computer the printer driver and other software that is appropriate to the operating system in use in that computer. For information on installing the required software, refer to the On-Line Manual that is located on the CD-ROM that is included with this product.

Remove the cover lacted at the back of the right side of the printer, and connect the printer cable to the parallel interface connector.

*If the optional Network Card is installed in the printer, connect the printer cable (100BASE-TX, etc.) and perform the appropriate network settings. Refer to “2-3 Network (TCP/IP) settings” on page 4.

Connect the other end of the printer cable to the parallel interface connector on your computer.

Turn the main switch to the printer back ON ( ).