Troubleshooting | Oce North America OP14 guide

	3. Troubleshooting

Error code	Procedure

E60	A read- or write-error has occurred on the RAM disk. Press the Start [GO] key to erase the error indication.

E70	A read- or write-error has occurred in the Memory Card. Press the Start [GO] key to erase the error indication.

E71	The Memory Card was removed during operation under the menu for printer-related settings. Reinsert the Memory Card.
	* BE SURE to turn the main switch OFF (O) BEFORE inserting the Memory Card.

E72	The Memory Card could not be detected during an operation in which the printer was reading data from that card. Reinsert
	the Memory Card.
	* BE SURE to turn the main switch OFF (O) BEFORE inserting the Memory Card.

E73	Initialization of the Memory Card currently inserted is necessary.

E80	A data overrun error has occurred due to insufficient memory.
	• If you want to force-continue the print job, press the Start [GO] key. If you want to cancel the printing operation completely,
	press the Stop/Reset key.
	• If “Auto Continue” (menu: P74) is turned “On” (setting: 1), the printing operation will be restarted automatically after the
	amount of time specified there.
	• Once this error message is displayed, “Page Protect” (menu: P42) will be turned “On” (setting: 1) automatically.

E82	The current print job could not be completed due to insufficient memory in the printer.
	• If you are using a RAM disk, reduce the size of the RAM disk. If this error occurs often, it is recommended that you install
	additional memory into the printer. For more detailed information on adding memory, contact your service representative or
	an authorized service center.
	• If you want to force-continue the print job, press the Start [GO] key. The data that has already been processed will be printed
	out and the remaining portion of the print job will be printed onto the following page.
	• If “Auto Continue” (menu: P74) is turned “On” (setting: 1), the printing operation will be restarted automatically after the
	amount of time specified there.

E83	The selected interface is currently in use. Wait for a while and then attempt the operation again.

EF1	An error has been detected during operation. Turn the main switch to the printer OFF (O) and then back ON ( ) again. If the
	same error message remains, contact your service representative or an authorized service center.

EF2	An error has been detected during operation. Turn the main switch to the printer OFF (O) and then back ON ( ) again. If the
	same error message remains, contact your service representative or an authorized service center.

3. Troubleshooting

EF1

EF2