Opticon OPT-6125 user manual Quiet Zone Settings

Page 59

Manual No. 25-ULGPMU01-01

Series OPT Handheld

CCD Scanner

 

Quiet Zone Settings

ZZ

Start/End

-[[-

ProgramMenu

YN

No margin

-ZO-

check

 

 

 

YO

Margin

-ZP-

check 1/7

 

normal

 

 

 

 

YP

Margin

-ZQ-

check 2/7

 

normal

 

 

 

 

YQ

Margin

-ZR-

check 3/7

 

normal

 

 

 

 

YR

Margin

-ZS-

check 4/7

 

normal

 

 

 

 

YS

Margin

-ZE-

check 5/7

 

normal

 

 

 

 

YT

Margin

-ZU-

check 6/7

 

normal

 

 

 

 

YU

Margin

-ZV-

check

 

normal

 

 

 

 

With these settings, the reader can decode bar codes that have smaller start and/or end margins than specified for the symbology. These settings may increase the possibility of partial and ghost reads, hence do not use smaller margin checks than necessary. Replace any bar code labels with ones that have the correct start and end margins if possible.

Page 59

Page 58 Page 60
Image 59
Page 58 Page 60
Contents
User’s Manual Page Table of Contents Factory Technical Support General InformationUnpacking Installation Keyboard Wedge Interface Part II Installation and SetUpComputer Type Selection for Keyboard Wedge only Reset All Defaults Keyboad Wedge InterfaceIntercharacter Delay for Keyboard Wedge interface Reset All Defaults RS232 Installation RS232 InterfaceBaud Rate RS-232C Communication Parameters Handshaking ProtocolData Bits / Stop Bits / Parity Reset All Defaults USB Interface Installation USB InterfaceWhat If I Make a Mistake? Step-by-StepStart/End Symbology SelectionSymbology Selection Symbology Additions Symbology Additions Setting the Number Characters to be Scanned Options for UPC-A and UPC-E bar codes UPC SettingsOptions for UPC-E UPC SettingsString format Options for UPC-AEAN-13 and EAN-8 Settings Options for EAN EAN-13 and EAN-8 SettingsCode 39 Settings Minimum Digits Options for Code Code 39 SettingsABCD/ABCD Codabar SettingsOn Next Codabar Settings Start Data 1 or Check Stop Char More chars Digit Options for Codabar 2of5 Settings Options for Code 2of5 2of5 SettingsOptions for MSI/Plessey MSI/Plessey SettingsManual No -ULGPMU01-01 Series OPT Handheld CCD Scanner Code 128, EAN 128 Settings Manual No -ULGPMU01-01 Series OPT Handheld CCD Scanner Digits Options for Iata Iata SettingsCode DescriptionOptions for Telepen Telepen SettingsCase Conversion Prefix Settings Setting a Prefix or SuffixPrefix Settings Suffix Settings Suffix Settings Direct Input Keyboard Keys Direct Input Keyboard Keys Capslock Direct Input Characters Direct Input Characters Direct Input Characters ProgramMenu Direct Input Characters Direct Input Characters Direct Input Characters Direct Input Characters Direct Input Control Characters Direct Input Control Characters Direct Input Code ID/Length Read Mode Settings Multiple Read Reset Time Trigger SettingsQuiet Zone Settings Read Time Settings Positive and Negative Bar Codes Redundant Decoding SettingsBuzzer Settings Buzzer Volume Buzzer Settings Good Read LED Diagnostics
Top Page Image Contents