Manual No.
Series
24. Selecting the Read Mode
Computer | Function | Bar Code |
|
Command | /Description | Command |
|
(Z7) | START/END | ,Z7, |
|
Programming Menu |
| ||
|
|
|
|
S0 | Single Read Mode | ,S0, |
|
(Trigger enabled mode only) |
| ||
|
|
|
|
S1 | Multiple Read Mode | ,S1, | B |
|
|
| |
|
|
|
|
S2 | Continuous Read Mode | ,S2, |
|
|
|
|
|
The operation of the scanner in the various read modes is described in the table below. The “Continuous Read” mode is helpful in positioning the scanner for optimum reading. In “Continuous Read,” the scanner’s buzzer functions like a Geiger counter, sounding the most active at the position achieving the greatest number of good reads.
Mode | Trigger Function Enabled | Trigger Function Disabled | |
| After receiving a trigger pulse, | Scanner will read different bar codes | |
| scanner will read multiple, | ||
| in succession if they are presented to | ||
| different bar codes in succession | ||
Multiple | the read window. | ||
Read | until it times out. |
| |
Scanner will not read the same | Scanner will not read the same bar | ||
| |||
| bar code twice if they are | ||
| code twice if they are consecutive. | ||
| consecutive. | ||
|
| ||
| Scanner will read the same bar |
| |
Continuous | code continuously after receiving | Scanner will read the same bar code | |
Read | a trigger pulse until scanner | continuously. | |
| times out. |
| |
Single | Scanner will read only one bar |
| |
code after receiving a trigger | Same as Multiple Read mode, above. | ||
Read | |||
pulse. |
| ||
|
|
Page 47