Lanner electronic FW-7870 user manual Power Management Setup, Video Off Method

Page 36

3.7 Power Management Setup

The Power Management Setup allows you to configure you system to most effectively save energy while operating in a manner consistent with your own style of computer use.

ACPI Function : This item allows you to enable or disable the Advanced Configuration and Power Management (ACPI). The settings are “Enabled” and “Disabled”.

Power managemant : This option allows you to select the type (or degree) of power saving for Doze, Standby, and Suspend modes.

This table describes each power management mode:

Max Saving	Maximum power savings. Only Available for SL CPUs.
User Define	Set each mode individually.
Min Saving	Minimum power savings.

Video Off Method

This determines the manner in which the monitor is blanked.

V/H	This selection will cause the system to turn off the vertical and horizontal
SYNC+Blank	synchronization ports and write blanks to the video buffer.
Blank Screen	This option only writes blanks to the video buffer.
DPMS	Initial display power management signaling.

Video Off In Suspend

This determines the manner in which the monitor is blanked.

Configuration options: Suspend->off / Always ON

Suspend Type

Select the Suspend Type.Configuration options: PWRON Suspend / Stop Grant

Image 36

Contents FW-7870 Series User’s ManualRadio Frequency Emissions Notice Copyright and DisclaimersTrademark Acknowledgments Safety Instructions Getting Technical Assistance About this ManualTable of Contents Terms and Conditions Warranty Policy RMA Service Features Getting StartedIntroduction Technical Specifications Packing Contents MB-X76 System Board Board LayoutJumper Settings and I/O Connector Connector Pin AssignmentsPSC124 Pin ATX Power Connector USBF1：USB Port #1 & #2 Connector 2x5 Pin 2.54mm FW-7880 19 1U Rackmount Firewall Mechanisms Face PanelFace Panel LED Status and Behavior OrangePage Rear View FW-7870 Rear ViewFW-7870 Hardware Installation Guide Removing the Top CoverCPU Installation Page System Memory Installing Hard Disk Drive Put the Hard disk on the bracket, and screwing 4 screwsInstalling Compact Flash Card Installing the Mini-PCI CardAward Bios Setup Bios SetupStarting Setup Using SetupNavigating through the menu bar Getting Help„ Advanced Chipset Features Main MenuStandard Cmos Features Options Description DateIDE Adapters Advanced Bios Features Page Advanced Chipset Features Dram Timing ControlPage Integrated Peripherals Onboard Serial Port 1/2 Auto Page Page Power Management Setup Video Off MethodSuspend Mode PnP/PCI Configuration Reset Configuration DataPC Health Status Load Optimized Defaults Supervisor/User Password SettingLoad Optimized Defaults Y/N ? N Save and Exit Setup Enter PasswordSave to Cmos and Exit Y/N? Y Exit Without Saving Quit without saving Y/N? YPower Supply Power Supply Specification AC Input SpecOutput Specifications FeatureWatchdog Timer Detail Register DescriptionsCRF6 Default P e n d i x C Console RedirectionLCD Module and Key Pad For FW-7870 LCM & KeyPad Function Library descriptionPage Warranty Policy Terms and ConditionsRMA Service Request Form Without this form your RMA will be RejectedPEXNSD01-040709 Version 1.0 Printed and published in Taiwan