Lathem ATDDC4 manual Atx

Page 2

THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS

PURSUANT SUBPART J OF PART-15

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

NOTE: This equipment has been tested and found to comply with the limits for a digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This Transceiver must not be co-located or operating in conjunction with any other antenna or Transceiver.

Disclaimer

The information within this document has been carefully checked and is believed to be entirely reliable. However, no responsibility is assumed for inaccuracies. Lathem Time Corp. reserves the right to make changes to any products herein to improve reliability, function, or design.

Trademark

AirTime, Lathem and the Lathem logo are registered trademarks of Lathem Time Corporation. Other product names mentioned in this manual may be trademarks of their respective companies and are hereby acknowledged.

WARNING: Changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

Copyright © 2009 Lathem Time Corporation. All rights reserved.

Lathem Inc

200 Selig Drive SW

Atlanta, GA 30336

www.lathem.com

Other AirTime Products

ATX

Mini Transceiver capable of

 

receiving the WWVB signal and

 

transmitting exact time in smaller

 

facilities

AT12RPS Solar Powered 12” Analog

Wireless Wall Clock

AT-ANTODOutdoor Antenna for maximum coverage with the ATX6 or the AT20WT

AT-MSXAirTime receiver that accepts the AirTime signals from an ATX, ATX6 or AT20WT and

corrects Lathem RS485 devices or Intercom systems via a 12:00AM dry contact closure

Contact your distributer or visit www.lathem.com for more information

Image 2
Contents Model ATDDC4 Installation & User’s Guide ATX Clock Operation One Year Limited WarrantyIntroduction Front Panel Front Panel with optional 6 digit displayTime Formats Clock InstallationSpecifications Ordering OptionsJumper J1 On = 12 Hour display Off = 24 Hour display Back Side of Circuit BoardMounting the Enclosure Double Mount Ceiling Mounting to a WallMounting to a Single Gang Box Double-Mounting CeilingPower Cord Installation Double Mount Wall Attaching ConduitMaking the Connection Double-Mounting Wall