Quick Setup

1.Insert two AAA batteries into the Remote Control Sender.

2.Insert two AAA batteries into the Indoor Temperature Station.

3.Wait 5-6 minutes, or until the outdoor temperature is displayed in the OUTDOOR LCD of the Temperature Station.

4.Set the Time

5.Mount units.

(See complete instructions for details).

Note: The Remote Control Sender transmits a signal every 3 minutes. After the batteries have been installed, the Indoor Temperature Station searches for these signals for a duration of 6 minutes. If there is no temperature reading in the OUTDOOR LCD after 6 minutes, make sure the units are within range of each other, or repeat battery installation process.