La Crosse Technology WS-8011UM II Program Mode, Function Buttons, Time Zone Setting

Page 5

Radio reception

 

 

 

 

 

flashes

with

the

WWVB

Alarm

time colon

(no

 

 

tower

icon

will

Dat

Outdoor temperature

appear

if

the

WWVB is

too

 

 

Weekday or

Indoor temperature or

weak

to

be

seconds display

seconds display

detected, and the

 

 

time display will remain on “-:--”). While the WWVB search is being conducted various numbers will appear in the time display. Within 10 minutes the temperature clock will either display the WWVB time, or discontinue the search if the time is not found. If the search is cancelled “-:--” will appear in the time LCD. The temperature clock will conduct a WWVB search every hour until the first signal is found. Once the WWVB time is found, a search is automatically conducted nightly at midnight. If the signal is found at midnight, the tower icon will remain, if not, another search will take place every hour (until 6:00 am) until the signal is found successfully. If no signal is found during this period, the tower icon will not appear and the clock will search again at 12:00 am the next night.

II)PROGRAM MODE

To enter the Program Mode hold down the “SET” button for 2 seconds, until “-5EST” flashes in the Date LCD. The Program Mode is laid out in a manner that allows you to program each function separately, or you can follow the instructions entirely to program the temperature clock. Complete programming is usually done for the initial set-up, and will require you to skip step 1 of programming sections C through H. Press and release the “SNOOZE” button at any time to exit the Program Mode, or wait approximately 15 seconds for the temperature clock to automatically return to normal operation.

A)FUNCTION BUTTONS

There are 4 function buttons located on the backside of the temperature clock. The function buttons are labeled: “SET”, “+”, “ALARM”, and “SNOOZE”.

B)TIME ZONE SETTING

1)Hold down the “SET” button for 2 seconds, the default (factory) setting “-5EST” will flash in the Date LCD.

2)Press and release the “+” button to select the appropriate time zone. There

-4ATL

Atlantic Time

-5EST

Eastern Time (default setting)

-6CST

Central Time

-7MST

Mountain Time

-8PST

Pacific Time

-9ALA

Alaskan Time

-10HAW

Hawaiian Time

-11, -12

Next two time zones West of HAW

GMT

Greenwich5Mean Time

-1, -2, -3GMT

Three time zones West of GMT

Image 5
Contents WS-8011UM 433 MHz Radio Controlled Temperature Clock Table of Contents Quick SET-UP Guide Inventory of ContentsTemperature Clock Function Buttons II Program ModeTime Zone Setting Language Selection for the Weekday DST Daylight Saving Time SettingTime Setting 12/24-HOUR Setting Calendar SettingSelecting F or C Alarm Setting the AlarmSuspending Alarm ACTIVATING/DEACTIVATING the AlarmIndoor Temperature Remote TemperatureWall Mounting IV MountingFoldout Table Stands VI Maintenance & Care Remote Temperature SensorMounting with Screws Mounting with Adhesive TapeSpecifications for WS-8011UM TroubleshootingWarranty Information FCC ID OMO-01RX receiver OMO-01TX transmitter