La Crosse Technology WS-8011UM instruction manual IV Mounting, Foldout Table Stands, Wall Mounting

Page 10

IV) MOUNTING

Hanging Holes

Function Buttons

Foldout Table Stands

There are two possible ways to mount the temperature clock:

•use of the foldout table stands

•wall mounting

A)FOLDOUT TABLE STANDS

The Foldout table stand legs are located on the backside, at the lower corners, and on both sides of the battery cover. The hinges are towards the edges of the temperature clock and the ends (with no hinge) need to be folded out towards the edge. Once the foldout table stands are extended place the temperature clock in an appropriate location.

B)WALL MOUNTING

1)Using a straightedge, horizontally space at 3- 15/16 of an inch (100.58mm) three screw positions on a wall.

2)Install three mounting screws (not included) into a wall within transmission range—leaving approximately 3/16 of an inch (5mm) extended from the wall.

3)Place the temperature clock onto the screws, using the hanging holes on the backside. Gently pull the temperature clock down to lock the screws into place.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents WS-8011UM 433 MHz Radio Controlled Temperature Clock Table of Contents Inventory of Contents Quick SET-UP GuideTemperature Clock Time Zone Setting II Program ModeFunction Buttons Time Setting DST Daylight Saving Time SettingLanguage Selection for the Weekday Calendar Setting 12/24-HOUR SettingAlarm Setting the Alarm Selecting F or CIndoor Temperature ACTIVATING/DEACTIVATING the AlarmSuspending Alarm Remote TemperatureFoldout Table Stands IV MountingWall Mounting Mounting with Screws Remote Temperature SensorVI Maintenance & Care Mounting with Adhesive TapeTroubleshooting Specifications for WS-8011UMWarranty Information FCC ID OMO-01RX receiver OMO-01TX transmitter
Top Page Image Contents