Ultra electronic manual Removing the cover Magicard 300 and Sprinter models

Page 2

1.(a) Removing the cover

Magicard 300 and Sprinter models.

(1)Set the printer On/Off switch to off(0) and isolate from the mains supply. Remove the card cassette and Dye-Film from the

printer.

(2)Position the printer on its side with the rear of the printer facing towards you and remove the five securing screws from the base of the printer plus the two at the rear of the printer.

(3) Place the printer on its base with the front of the printer facing towards you.

(4) Lift the printer cover from the rear and carefully remove it from the printer taking care not to strain the ribbon cable connection from printer circuit board PL8, and place the cover aside.

3461/07/01 ISSUE 2

PRINTHEAD INSTALLATION & COMMISSIONING SPEC.

DCR No. 26106

II

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Magicard Printer Removing the cover Magicard 300 and Sprinter models Removing the cover Magicard Turbo models Removing old printhead/assembly Fitting the new printhead assembly into the printer Setting up your new thermal printhead Refitting the coverTWO Types of Nylon Side Brackets Finally Too Positive
Top Page Image Contents