1.(b) Removing the cover Magicard Turbo models.
(1)Set the printer On/Off switch to Off(O) and isolate from the mains supply. Remove the card cassette and the
the printer.
(2)Position the printer upside down with the rear of the printer facing towards you and remove the four securing screws from the base of the printer plus the eight at the rear of the printer.
(3) Position the printer with the front panel facing upwards. Remove the two screws from the underside of the front panel and remove the two screws from the top left and top right of the front panel.
(4)Turn the printer back onto its base and lift off the front cover. Using an M4 spanner loosen the bolt at the right hand end of the Door Locking Shaft and disconnect the operating lever from the shaft.
(5) Flex out the sides of the cover and lift it carefully away.
3461/07/01 ISSUE 2 | PRINTHEAD INSTALLATION & COMMISSIONING SPEC. | DCR No. 26106 |
III