Ultra electronic 300plus quick start Test Printer Operation G

Page 15

Ultra Electronics Card Systems

Quick Start Guide

Test the

Printer Operation G

Print an Internally-Generated Test Card to make sure your printer is working correctly:

12

At the rear of the printer, locate the TEST Push-button. This is located in the rear panel, just above the Centronics parallel interface connector.

In early models, it may be located through a small hole in which case it may be operated by means of a small insulated screwdriver, match-stick or blunt cocktail stick.

Press the push-button momentarily.

It will take a few seconds before printing commences. When finished, a Test Card will be ejected from the aperture in the Front Panel.

3

The card should be as shown, with Yellow-Magenta-Cyan-Black panels, a Cyan background and Yellow-Magenta- Cyan graduated scales. This card can only be printed by a printer in isolation, when using UR1 Dye Film. Note also that

MAGICARD Color Printer

Page 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents
Magicard 300plus Magicard Sprinter Magicard 300 Color PrinterLoad the supplied Windows Driver software Verify computer-to-printer operationConventions Page Location Requirements for your printer Preparing a Location For the PrinterTop Cover Removing the Printer From the Box Checking Package Contents C Quick Start Guide Ultra Electronics Card Systems Install Dye Film D Quick Start Guide Ultra Electronics Card Systems Ultra Electronics Card Systems Quick Start Guide Load Plastic Cards 545 Connect the Printer To a Power Supply Test Printer Operation G Internal software version is printed on the test card Install the parallel Interface Cable H and Ultra Secure Key Procedure to be followed if your PC uses Windows 3.1 or Install Windows DriverUltra Electronics Card Systems Quick Start Guide Quick Start Guide Ultra Electronics Card Systems Press the Set as Default Printer button Procedure to be followed if your PC uses Windows Install Windows Driver Iy∙ Select the Next button ∙ Select the Have Disk button Quick Start Guide Ultra Electronics Card Systems Ultra Electronics Card Systems Quick Start Guide Quick Start Guide Ultra Electronics Card Systems Printer Setup Printer SetupStandard Magicard Color Printer Quick Start Guide Ultra Electronics Card Systems Overcoat Magicard Color Printer Colour Adjust Parallel Port Configuration Verifying Computer to Printer Communication in Windows Check the Installation Case DifficultyFor Further Assistance Thermal Printhead Cleaning Important Cleaning Procedures MCleaning the Rubber Rollers Cleaning the Tacky RollerQuick Start Guide Ultra Electronics Card Systems Cleaning the Magnetic Head if fitted Cleaning the OpticsLED Error Codes N Canadian Department of Communications Statement Limited Warranty Information Fax +44 01305 EC Declaration of Conformity Safety