Proview XM9-23w manual Method 2 Digital DVI Connection

Page 17

Installation

Method 2: Digital (DVI) Connection

1Turn off the computer and unplug the power cable.

2Connect the signal cable (DVI-D) to the DVI port on the back of the computer.

3Connect the audio cable to the line-in port on the back of the computer.

4If you would like to listen to PC audio with a headphone, connect the audio out port to the headphone.

5Connect the DC plug of the AC-DC adapter to the DC 24V port at the rear of the monitor. Connect the power cord to the AC-DC adapter and wall outlet.

6Press the button, located on the bottom side of the main unit to turn the monitor on, then turn the computer on. If the monitor displays an image, the monitor is successfully installed. If no image is displayed, check all connections.

16	Xerox© LCD Monitor User’s Manual

Image 17

Contents LCD Monitor By Xerox Corporation. All rights reserved Table of Contents English Europe Recycling PlaceCE Marking Declaration Of Conformity Federal Communications Commission FCC Statement Important Safety Instructions Important Safety Instructions Collection service Introduction FeaturesPackage Contents Front View and Controls LED Connecting Your LCD Monitor to a Computer InstallationConnect to power source Connect to the Headphone Method 2 Digital DVI Connection Connect to power source Connect to the DVI port 30o Using Your LCD MonitorInstall Installing the Speakeroptional to Your LCD MonitorRemove Installing the Wall Mount optional to Your LCD Monitor OSD Menu Using the OSD MenuPress the or button to select the desired adjustment item On Description OSD OptionsPicture Setup Menu provides access to the following menus Picture Setup MenuUser Sound Setup Menu Reset OSD Setup MenuTechnical Information Preset Mode Timing ChartPIN Description DVI Connector PIN AssignmentSUB Connector PIN Assignment Visual Inspection Plug and PlayNo picture TroubleshootingModel SpeciﬁcationsAuthorized Service Centers