Rimage AutoEverest AutoPrinter™
Setup and Installation Guide
Before you begin:
This document is intended for people who are familiar with hardware setup, software installation, and Windows operating systems.
If you do not understand the procedures in this document, ask your computer technician for help.
This document describes how to set up your Rimage AutoEverest AutoPrinter. If you are using the Everest printer as a standalone printer or with an autoloader, refer to the printer or autoloader’s setup and installation instructions.
Documents referenced in this procedure shipped with your product and are also available online at www.rimage.com/support. Select: Printer Series > AutoPrinter >
2 Prepare the Everest
a.Unpack the Everest printer. Refer to the label on the Everest printer box.
b.Follow the instructions on the instruction card on the rear of the printer.
i.Set the AC voltage switch.
ii.Move the shipping screw to the storage position.
Voltage Switch
Instruction Card
Shipping Screw Shipping Screw
Storage Position
Side Cover Latches
User Manuals tab.
•Read all setup instructions thoroughly before you begin.
•Save all packing boxes and packing materials for your AutoPrinter and Everest printer.
Note: Your product may not look exactly like the product pictured.
## Required tools: Scissors or side cutters
1 Prepare the AutoPrinter
a.Cut the plastic tie wraps (Qty. 2) from the lift arm.
c.Open the Everest printer.
i.Press the two side cover latches.
ii.Lower the side cover.
d.Open latches 1, 2, and 3 as indicated by the arrows.
Latch 1 | Latch 2 | Latch 3 |
nnCaution! Do not cut the belt or the cable!
b.Remove the shipping foam inserted above the carousel.
Shipping
Foam
Tie 
Wraps
e.Remove the plastic packing pieces (Qty. 2) from inside the printer.
f.Install the print ribbon and retransfer ribbon. Refer to the instruction label on the side cover, or refer to the Everest Printer User Guide.
Plastic Packing Pieces
Copyright © 2009 Rimage Corporation | Page 1 |