Setup Your Everest Printer, Test and Verify

3 Setup Your Everest Printer

Place the printer on the AutoPrinter so that the plastic printer feet slide into the slots on the printer plate.

Printer Plate

Slots

4 Connect the Cables

6 Install the CD Designer Software Suite (PC Only)

Before you can operate an AutoEverest AutoPrinter, you must install the Rimage software (PC users only) and Everest printer driver (step 7).

--Important! CD Designer is not Macintosh® compatible.

Note: Unless otherwise indicated, all Windows navigation statements are Windows XP paths. Windows Vista, Windows 2000, and Windows Server 2003 navigation may differ slightly.

a. Insert the Rimage CD Designer Software Suite disc that shipped with the

AutoPrinter into the PC disc drive.

b. Open the file named setup.exe.

c. Follow the prompts to install the software. The CD Designer software is

installed.

d. Activate your warranty.

Note: Product registration for printers and AutoPrinters using software

a.Connect the printer cable from the AutoPrinter to the Everest printer.

b.Connect the short power cord from the AutoPrinter to the Everest printer.

c.Connect the USB cable from the Everest printer to the control center (PC).

d.Connect the power cord from the AutoPrinter to a suitable electrical outlet.

version 8.2 or higher is now managed through the Rimage website at

www.rimage.com/support/warranty-registration.

7 Install the Printer Driver

For detailed instructions, refer to the Install the Everest Printer Driver section of the Rimage Everest Printer User Guide.

8 Test and Verify

Run a three-disc test job to verify that the system is operating correctly. Refer to the Getting Started with Rimage Software document.

Notes:
•	AutoPrinter III systems: The printer alignment is preset and should
	not require adjustment.
•	AutoPrinter II systems: If the disc is not centered on the printer tray
	or there are clamping errors, refer to the Align the Printer instructions

5 Power on the AutoPrinter

a.Press the power switch on the back of the AutoPrinter. Power

Switch

b.Power on the control center (PC).

The system powers on and the AutoPrinter begins the initialization process.

Note: Initialization may take up to 5 minutes.

in the Rimage AutoPrinter User Guide.

9 Learn More

For information about operating and maintaining your AutoEverest AutoPrinter, refer to the Rimage AutoPrinter User Guide included with your product.

For additional support and product information, go to www.rimage.com/support.

110660-001_F

Page 2