TVS electronic RP-35 specifications Features

Page 4

1. Features

♣Dip Switch Configuration

Emulation mode, communications mode, baud rate, serial/parallel handshake, and head printing characteristics are all configured through dip switch settings.

♣Data Buffer

The Jus' Bill RP-35 printer has a built-in 16 Kilobyte I/O buffer allowing the host computer to free itself after sending the print data.

♣Reliable communications

The Jus' Bill RP-35 supports multiple baud rates, protocols, and handshaking on its parallel & serial interfaces.

♣User controls

A power switch, a paper feed switch, power LED and Paper Low/Out error LED provide ease of use.

♣Self Test Mode

A comprehensive self-test mode is available which describes the printer configuration and dip switch setting information along with the version number of firmware installed.

♣Print orientation

The printer is capable of printing normal and upside down, the print orientation is selected by software commands.

♣Selectable international characters

The Jus' Bill RP-35 supports international characters selectable by software control.

♣Multiple Fonts/Sizes

Two different resident fonts are available for printing diversity. Each of these fonts can be printed in normal, double wide, double height, and quadruple sizes. Both fonts and sizes are software selected.

♣Bit image graphic

Two formats for bit mapped graphics are provided.

♣Error detection

The Jus' Bill RP-35 can detect paper-out and paper-jam as well as paper near-end, controller malfunction, and cover open status.

♣Peripheral Drive

Two cash drawer drivers are provided.

♣Certification

(1)This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)this device may not cause harmful interference , and

2)this device must accept any interference received , including interference that may cause undesired operation.

(2)UL/cUL (UL 60950-1)

(3)MIC

(4)CE-EMCD (CE-EMCD Class B should use Parallel shield Cable complied with IEEE-1284 standards)

(5)RoHS (TUV)

(6)CCC

3

Image 4
Contents Model Jus’ Bill RP-35 Page Table of Contents Features Specification Printer SpecificationsOverall dimension Configuration Setup Self TestDTR/DSR CPLUser Switches Panel SwitchesPower Switch IndicatorsCommand List BEL CanDC1 DC2ESC M DC4ESC W Interface USB ComboPIN DescriptionPIN Signal Description Strobe ErrorPIN Signal DATA0~7Cash Drawer Connector PIN Signal DescriptionElectrical Specifications Dip Switch Settings This table gives the definition for the DIP switch settingsSW2 Page Rev