3. Self Test
While pressing the paper feed switch for more than 10 seconds after the printer in turned on, the self test mode is initiated.
The printer self test includes a listing of the current default settings, read and write test of internal RAM, checksum test of internal program memory, loop back detection statement, a staggered dot line, a few lines of rotating character set, and a diagnostic report.
The printer then enters into the
Configuration Setup
When the paper FEED switch is pressed and released instantly as the power is applied to the printer, the printer will print the current printer configuration settings along with the DIP switch information.
If the printer setup needs to be changed, turn the Power Off before changing the setting.
The printer will be setup at the factory as follows;
Printer is setup as follows: |
|
Model : | Jus' Bill |
Firmware : | Ver X.XX |
Interface : | Serial |
Emulation : | Epson |
CR Character : | CR=CR only |
Flow Control : | DTR/DSR |
Data Bits : | 8 Bits |
Parity : | None |
Baud Rate : | 9600 |
CPL : | 40/33 Char / Line |
Two Color : | Installed |
Auto Cutter : | Installed / Not Installed |
Journal : | Installed / Not Installed |
6