Thermaltake W0296, W0295, 800W manual Power Connector Introduction Installation Steps, Cable Model

ToughpowerTM 700W / 800W	ToughpowerTM 700W / 800W
3. Power Connector Introduction	4. Installation Steps

Cable

P/N Model		20+4pin Main	4pin +12V CPU	8pin +12V CPU	SATA	Peripheral	Floppy	8pin PCI-E	6pin PCI-E	PCI-E (8 to 6)
		Connector	Connector	Connector	Connector	Connector	Connector	Connector	Connector	Connector
W0295	700W	1	1	1	6	5	1	2	2	2
W0296	800W	1	1	1	6	5	1	2	2	2

Note: Make sure that your system is turned off and unplugged. Disconnect the AC power cord from your old power supply.

1.	Open your computer case; please refer to the direction in your
	case manual.
2.	Install the PSU into the case with the four screws provided.

Connector Type

20+4pin

	ATX 12V	4pin
MODELS	EPS 12V	8pin
700W
800W	Molex & FDD

SATA

PCI-E 8/6pin

Connectors & Cable length

1 x 20+4pin Main connector

(500mm)

1 x ATX 12V 4pin connector

(500mm)

1 x EPS 12V 8pin connector

(500mm)

2 x Peripheral & 1 x FDD connectors (500mm + 150mm + 150mm)

3 x Peripheral connectors

(500mm + 150mm + 150mm)

3 x S-ATA connectors

(500mm + 150mm + 150mm)

3 x S-ATA connectors

(500mm + 150mm + 150mm)

1 x 8/6pin PCI-E connectors

(500mm + 150mm)

1 x 8/6pin PCI-E connectors

(500mm + 150mm)

3. Connect the 24 pin Main Power Connector to your motherboard

and peripheral. If your motherboard uses a 20-pin

connector, detach the 4-pin attachment on the 24-pin connector.

Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V

connector.

4.Connect the 8-pin or 4-pin connector for the CPUs.

5.Connect other peripheral power connectors to devices such as

hard drives, optical drives, etc.

6.Close your computer case and connect the AC power cord to the power supply AC inlet.

03 04