Telenetics MOT202TRM, MOT202TSA manual Powering-on the Modem, Powering-off the Modem

Page 19

Installation

Powering-on the Modem

To supply power to the modem, place the POWER ON switch on the modem back panel to the ON position. The PWR LED on the front panel goes ON.

Powering-off the Modem

To turn off power to the modem, place the POWER ON switch on the modem back panel to the OFF position. The PWR LED on the front panel goes OFF.

Page 20

Image 19

Contents

MOT202TSA/MOT202TRM Contents Leds and Controls Chapter Introduction Summary of Key FeaturesModels Using This ManualVoice Calls Contact InformationIntroduction Site Preparation Installing the ModemUnpacking Your Hardware Hardware Overview Additional Items You NeedConfiguring the Modem Configuring the ModemModem Jumper Locations Jumper Settings Jumper S2 − Transmit Level Jumper S1 − Carrier Detect ControlJumper S4 − Call Turnaround Squelch Jumper S3 − 2-wire/4-wire Mode Jumper S5 − Transmit Carrier Jumper S8 − Signal and Earth Ground Jumper S6 − Local Copy Jumper S10 − Carrier Detect Delay Jumper S9 − RTS-CTS DelayJumper S11 − Turnaround Squelch Time Jumper S13 − Anti-Streaming Jumper S12 − Soft Carrier Turn OffConnecting to a Private Line Communication Circuit Connecting a DTEJumpers S14 and S15 − Self Test or Test Pattern Powering-off the Modem Powering-on the ModemTFront Panel LEDs Chapter LEDs and ControlsFront Panel Test Switch Analog Loopback Test Self Test Local Modem Test Chapter TroubleshootingLine and Modem Test TGeneral Chapter SpecificationsTemperature Range Dimensions and WeightPower Requirements Telco Connector DTE Connector EIA RS-232-CInterface Pin Assignments Specifications FCC Rule Appendix a CompliancesDepartment of Canada Statement Appendix B Limited Product Warranty Limited Product Warranty