Telenetics MIU2.4 manual MIU Installation, Operation & Diagnostics Edition March 30

Page 30

0 Normal hang up; no error occurred.

4Physical carrier loss. (Loss of Carrier)

5Feature negotiation failed to detect presence of another V.42 error-control modem at other end.

6Other error-control modem did not respond to feature negotiation message sent by this modem.

7Other modem is synchronous-only; this modem is asynchronous-only.

8Modems could not find a common framing technique.

9Modems could not find a protocol in common.

10Feature negotiation message sent by other modem incorrect.

11Synchronous information (data of flags) not received from other modem.

12Normal disconnect initiated by other modem.

13Other modem did not respond after many transmissions of the same message. Modem made 10 attempts then hung up.

14Protocol violation occurred.

15Compression failure.

Note: Multiple occurrences may contribute to a NO CARRIER message; S86 records the first event that occurred.

MIU Installation, Operation & Diagnostics Edition: March 30, 1998

Page 28

Image 30
Contents Installation, Operation & Diagnostics Telenetics Corporation Table of Contents Standards USAProduct Overview MIU Installation, Operation & Diagnostics Edition March 30 General Product Specifications MIU28.8Power Down Power ModesMode Description Power Consumption Power On SleepModem Specifications MIU2.4 MIU9.6 MIU14.4 MIU28.8Power Connections Serial Data Port PIN-OUTS DIP Switch Settings Not Applicable LED Indicator Auto Reset FeatureAuto Dial Feature Outline Drawing & Mounting Modem Configuration Factory Configuration ~ MIU2.4 Active Profile Stored ProfileTelephone Numbers &Z0= Factory Configuration ~ MIU9.6 Active Profile Telephone NumbersFactory Configuration ~ MIU14.4 Active Profile Factory Configuration ~ MIU28.8 Active Profile Diagnostics T0 Terminate Test in Progress T1 Initiate Local Analog Loopback See FigureResult Code Description No Function Perform Local Digital Loopback See FigureGrant Remote Digital Loopback RDL Requests T5 Deny RDL Requests T6 Initiate Remote Digital Loopback See FigureT7 Initiate RDL with Local Self Test See Figure Result Codes DescriptionT8 Local Loopback with Self Test See Figure T6, &T7, or if on-lineMIU Installation, Operation & Diagnostics Edition March 30 MIU Installation, Operation & Diagnostics Edition March 30 MIU Installation, Operation & Diagnostics Edition March 30 Received Line Signal Quality S86 Connection Failure CauseMIU Installation, Operation & Diagnostics Edition March 30 MIU Installation, Operation & Diagnostics Edition March 30