Telenetics Modular Nest manual Removing a 326X Backplane

	Part No. TEL–09949, Rev A
Removing and Installing a Backplane in Modular Nest 9 or 21 Enclosure	June 2001
	Page 28 of 34

Removing a 326X Backplane

Caution

Power down the unit before you begin.

To remove a backplane from a Modular Nest 9 or 21 enclosure (Figure 14):

1)Ensure that the enclosure is powered down.

2)Remove all cards from the front of the enclosure.

3)Using a flat-blade screwdriver, unfasten the backplane connectors.

4)Pushing up from beneath the connectors near the top of the backplane, lift the backplane vertically, very slightly, to disconnect it from the power distribution connector (A).

5)Tilt the top of the backplane away from the enclosure (B), and remove the backplane (C).

6)Power up the enclosure.