SoundCraft 328 setup guide Pdif Input, Tape Ch17-24 Wordlength

Set the desired wordlength on the 328 with the rotary encoder.

<Tape Ch17->24 >

Wordlength: 24

Press the down cursor to set the port for 328 ADAT port B, as for port A, and again to set the wordlength for port B. Press <ENTER> to confirm the settings.

<Tape Ch25->32 > Bank Source:ADAT

<Tape Ch25->32 > Wordlength: 24

S/PDIF Input

The 328 S/PDIF input can be routed to any one of the following inputs:

Stereo Input 1, Stereo Input 2, FX Return 1, FX Return 2, 2 Track Tape Return,

providing that the AES/EBU input or oscillator has not already been assigned to that input.

Commonly the Dakota S/PDIF output would be routed to Stereo Input 2, or the 2 Track Tape Return input.

NOTE	Assigning a digital source to an input will override any analogue signal
	present on that input.

Press <MENU> to enter the menu pages, scroll through the pages until the ‘SPDIF I/P Setup’ is highlighted and press <ENTER>. Using the rotary encoder, select the destination for the S/PDIF input, and press <ENTER> to confirm the setting:

<SPDIF Input > Route To: STE-1

<SPDIF Input > Route To: 2TRK

<SPDIF Input > Route To: FX-1

<SPDIF Input > Route To:NOWHERE

NOTE	If the S/PDIF input is not required, NOWHERE should be selected in the
	menu.

Dakota Setup Guide

5