SOYO SY-7ISA+ Motherboard manual Voice Doctor, JP33 Setting, Clearing, JP5 Setting

Hardware Installation SY-7ISA+

2-3.5 Voice Doctor

If the system does not boot-up properly, the Voice Doctor will inform the user by voice through internal/external speaker at what point in boot-up sequence the problem arises.

Below are the possible errors the user may encounter: The Processor might be damage or not installed properly

The memory module might be damage or not installed properly No Keyboard connected

VGA card might be damage or not inserted properly Defective HD-Driver (IDE)

Floppy might error

Voice Doctor supports two language, refer the table below on the language you prefer.

Voice Doctor’s language English Language Chinese Language

JP33 Setting

Short pin 1-2

1 2 3

Short pin 2-3

1 2 3

2-3.6 CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear CMOS memory.

1.Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper can be easily identified by its white colored cap.

2.Then put the jumper back to 1-2 to allow writing new of data into the

CMOS memory.

CMOS	Clear CMOS Data		Retain CMOS Data
Clearing
	Short pin 2-3 for		Short pin 1-2
JP5 Setting	at least 5		to retain new
	seconds to clear		settings
	the CMOS	1 2 3	1 2 3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

44