SOYO SY-6IZA-NA Quick Bios Setup, Select Standard Cmos Setup, Select Load Setup Default

Page 12

Quick BIOS

Setup

 

 

SY-6IZA/6IZA-NAQuick Start Guide

3 Quick BIOS Setup

This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead, CPU settings are software configurable with the BIOS [SOYO COMBO SETUP]. The [SOYO COMBO SETUP] menu combines the main parameters that you need to configure, all in one menu, for a quick setup in BIOS.

After the hardware installation is complete, turn the power switch on, then press the <DEL> key during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.

Step 1. Select [STANDARD CMOS SETUP]

Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.

Step 2. Select [LOAD SETUP DEFAULT]

Select the “LOAD SETUP DEFAULT”menu and type “Y”at the prompt to load the BIOS optimal setup.

Step 3. Select [SOYO COMBO SETUP]

Move the cursor to the [CPU Frequency] field to set the CPU frequency.

Available [CPU Frequency] settings on your SY-6IZA/6IZA-NA Motherboard are detailed in the following table. If you set this field to [Manual], you are required to fill in the next two consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Ratio.

CPU Frequency

300MHz (66 x 4.5)

333MHz (66 x 5.0)

366MHz (66 x 5.5)

400MHz (66 x 6.0)

433MHz (66 x 6.5)

466MHz (66 x 7.0)

500MHz (66 x 7.5)

Select the working frequency of your CeleronTM processor among these preset values.

Note: Mark the checkbox that corresponds to the working frequency of your CeleronTM processor if the CMOS configuration is lost.

Note: if you use Bus Frequencies of 75 MHz, make sure that your PCI cards can cope with the higher PCI clock.

Step 4. Select [SAVE & EXIT SETUP]

Press <Enter> to save the new configuration to the CMOS memory, and continue the boot sequence.

12

Image 12
Contents Quick Start Guide SY-6IZA/6IZA-NA Motherboard 6IZA/6IZA-NA Serial Version 2.2- Edition MarchIntroduction UnpackingKey Features SY-6IZA Motherboard LayoutSY-6IZA-NA Motherboard Layout Installation Install the Motherboard Install the CPUReset Set JP45 for power up FSB clock and AGP bus clock DimmEnable/Disable Power-On by Keyboard JP1 Power Button Enable JP8Power Button EnableExternal Suspend Button JP2 Clear Cmos Data JP5Cmos Clearing Quick Bios Setup Select Standard Cmos SetupSelect Load Setup Default Select Soyo Combo SetupSoyo CD Insert the Soyo CD into the CD-ROM driveSoyo CD Start Up Program Menu Install Drivers and Utilities Driver Installation Menu Short description of all available drivers followsCheck the Latest Releases Enter the Soyo CDInstalling Software in Windows NT To install the software Testing the Installation in Windows NTTo test the installation Uninstalling AudioPCI in Windows NT Reinstalling the Audio Drivers From the Installation DiscTo uninstall the software Quick Trouble shoot tips Bios Issues Can not get my board to run properly How to contact us Soyo TaiwanSoyo Europe BV Soyo USASoyo Deutschland GmbH Soyo KoreaSoyo Hong Kong Soyo China Gin Mei JeiEdition March Version 6IZA/6IZA-NA Serial