SOYO SY-6IZA-NA quick start Can not get my board to run properly

Page 21

SY-6IZA/6IZA-NAQuick Start Guide

I do not get any sound from my sound card. What could be wrong?

Please make sure the speaker is connected to the speaker out port on your sound card.

In Device Manager, I keep getting yellow exclamation signs on my sound port even though I have installed my sound driver several times and I could not get my sound card to work. What is wrong?

It is likely that you did not have the correct driver installed. If you are sure that the correct sound driver has been installed, then please install the 'south bridge' driver for the motherboard.

The sound is working in my system, but when I play CD music from the CD- ROM, I do not get any sound. What is wrong?

This is because the 3-wire audio cable from the CD-ROM to the sound card is not connected or it is loose.

The sound from my sound card is distorted when Windows starts. What is wrong?

First, if you are using an ISA sound card, please make sure the IRQ needed for the sound card is set to 'Legacy ISA' in the bios. In other words, if your ISA sound card takes IRQ5, then set IRQ5 to 'Legacy ISA'. Next, install the 'south bridge' driver for the motherboard.

The sound and everything else works fine except that the recorder and microphone do not work. What is wrong?

This is because the recorder and microphone in the Windows are not enabled. Please go to sound properties and enable them.

Lock up (freeze)

When I boot up my system, everything works fine. It sees my CPU and memory, detects my hard drive, floppy drive and CD-ROM but locks up at "Verify DMI pool data... ", and it won’t go any further. What should I do?

Please clear the CMOS via JP5 then choose 'load setup default' in the bios and save the bios and exit. Next, unplug all other add-on cards except the video card and floppy drive controller, and see if it can boot from floppy. Then put back the peripherals one by one to identify which one causes the lockup. If you are running a Cyrix CPU, make sure the 'linear burst function' is enabled in the bios.

I can not get my board to run properly.

Please make sure you have the latest bios and driver from the SOYO web site at: http://www.soyo.com

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Quick Start Guide 6IZA/6IZA-NA Serial Version 2.2- Edition March SY-6IZA/6IZA-NA MotherboardUnpacking IntroductionSY-6IZA Motherboard Layout Key FeaturesSY-6IZA-NA Motherboard Layout Installation Install the CPU Install the MotherboardReset Dimm Set JP45 for power up FSB clock and AGP bus clockPower Button Enable JP8 Enable/Disable Power-On by Keyboard JP1Power Button EnableExternal Suspend Button JP2 Clear Cmos Data JP5Cmos Clearing Select Standard Cmos Setup Quick Bios SetupSelect Load Setup Default Select Soyo Combo SetupSoyo CD Insert the Soyo CD into the CD-ROM driveSoyo CD Start Up Program Menu Install Drivers and Utilities Short description of all available drivers follows Driver Installation MenuEnter the Soyo CD Check the Latest ReleasesInstalling Software in Windows NT To install the software Testing the Installation in Windows NTTo test the installation Uninstalling AudioPCI in Windows NT Reinstalling the Audio Drivers From the Installation DiscTo uninstall the software Quick Trouble shoot tips Bios Issues Can not get my board to run properly Soyo Taiwan How to contact usSoyo Europe BV Soyo USASoyo Korea Soyo Deutschland GmbHSoyo Hong Kong Soyo China Gin Mei Jei6IZA/6IZA-NA Serial Edition March Version
Top Page Image Contents